Strange growth on my stove pipe
- NEPApotbelly
- New Member
- Posts: 9
- Joined: Mon. Dec. 24, 2018 6:08 pm
- Hand Fed Coal Stove: US Stove Potbelly
Not sure if this is the right forum to post this topic in, but I've noticed a strange rusty growth on my stove pipe that happened at some point during the spring after I stopped using the stove at the end of the heating season. The pipe is the DuraVent brand, but I doubt that matters. The growth is dry in some areas and damp in others. See photos for more detail.
The concrete block chimney was in a bad state of disrepair. About a month ago, I removed what stucco remained and redid the stucco work on it, sealed up cracks around the flashing, etc.
My hypothesis is that the moisture build up came from the numerous cracks in the chimney block during our spring rains. Since I wasn't running the stove by mid-May, the lack of heat allowed moisture to build up in and around the pipe, allowing the rust to begin forming.
But let me know if I'm wrong or if you all have other theories.
One last note: I had the chimney inspected at the beginning of the heating season last fall. The inspector noted the bad shape of the block on the outside but said the flue inside was in good shape.
The concrete block chimney was in a bad state of disrepair. About a month ago, I removed what stucco remained and redid the stucco work on it, sealed up cracks around the flashing, etc.
My hypothesis is that the moisture build up came from the numerous cracks in the chimney block during our spring rains. Since I wasn't running the stove by mid-May, the lack of heat allowed moisture to build up in and around the pipe, allowing the rust to begin forming.
But let me know if I'm wrong or if you all have other theories.
One last note: I had the chimney inspected at the beginning of the heating season last fall. The inspector noted the bad shape of the block on the outside but said the flue inside was in good shape.
-
- Member
- Posts: 6077
- Joined: Wed. Jan. 18, 2017 11:30 pm
- Location: swOH near a little town where the homes are mobile and the cars aren’t
- Hand Fed Coal Stove: Hitzer 354
- Coal Size/Type: nut coal
- Other Heating: electric, wood, oil
Weird, for sure. I'm sure moisture crept in through your old chimney as you stated and possibly even around or through the Stucco if there were cracks. Stucco's a little different from EIFS and they've had some issues with EIFS application causing moisture issues. Some places won't even use it anymore I am hearing. Likely from the method of application or lack of being applied correctly in many cases. I would think Stucco and Drivet systems are subject to the same correct/incorrect application methods...as all three are human applied. My guess is, it could have, but likely didn't start with the Stucco, but with the chimney.
I've never seen anything like that. Sort of odd that it would wipe off. Of course, surface rust would wipe off also, but that stuff is just strange. Good thing you've documented it with pictures. You may think about having it analyzed somewhere just to see what in the world it is...if you want to spend the money to do so.
I've never seen anything like that. Sort of odd that it would wipe off. Of course, surface rust would wipe off also, but that stuff is just strange. Good thing you've documented it with pictures. You may think about having it analyzed somewhere just to see what in the world it is...if you want to spend the money to do so.
Last edited by Hoytman on Tue. Aug. 13, 2019 3:04 pm, edited 1 time in total.
-
- Member
- Posts: 2705
- Joined: Fri. Jan. 26, 2007 9:55 pm
- Location: Birdsboro PA.
- Stoker Coal Boiler: EFM 350
- Hot Air Coal Stoker Furnace: reading allegheny stoker
- Hot Air Coal Stoker Stove: alaska kodiak stoker 1986. 1987 triburner, 1987 crane diamond
- Coal Size/Type: rice
flyash and moisture will do that.
-
- Member
- Posts: 6515
- Joined: Sun. Feb. 10, 2008 3:48 pm
- Location: Cape Cod, MA
- Stoker Coal Boiler: want AA130
- Hand Fed Coal Stove: DS Machine BS#4, Harman MKII, Hitzer 503,...
- Coal Size/Type: Pea/Nut/Stove
ash and water make acid...
Replace the pipe...
Disconnect and keep it dry next year...
Happens all the time on The Cape with high humidity...
Worse if it is hooked up in the basement...
Replace the pipe...
Disconnect and keep it dry next year...
Happens all the time on The Cape with high humidity...
Worse if it is hooked up in the basement...
-
- Member
- Posts: 6077
- Joined: Wed. Jan. 18, 2017 11:30 pm
- Location: swOH near a little town where the homes are mobile and the cars aren’t
- Hand Fed Coal Stove: Hitzer 354
- Coal Size/Type: nut coal
- Other Heating: electric, wood, oil
Hmmnnn….learn something everyday, I guess. I've always known of coal and pipe corrosion, but I've never seen that. Of course, I've been mostly around wood burners most of my life. Good catch gang!!
- NEPApotbelly
- New Member
- Posts: 9
- Joined: Mon. Dec. 24, 2018 6:08 pm
- Hand Fed Coal Stove: US Stove Potbelly
Ok, thanks for the info. It didn't look like ordinary rust to me. Bummer about replacing the pipe though. It's not even one year old. Thanks!
- coaledsweat
- Site Moderator
- Posts: 13766
- Joined: Fri. Oct. 27, 2006 2:05 pm
- Location: Guilford, Connecticut
- Stoker Coal Boiler: Axeman Anderson 260M
- Coal Size/Type: Pea
Mine does that if I don't pull it off and clean it. It is probably good for another year, maybe two. Pop a blister and see if there is any penetration. If not, use it another year.
- freetown fred
- Member
- Posts: 30299
- Joined: Thu. Dec. 31, 2009 12:33 pm
- Location: Freetown,NY 13803
- Hand Fed Coal Stove: HITZER 50-93
- Coal Size/Type: BLASCHAK Nut
Same here C--depends on humidity, etc.
- CoalJockey
- Verified Business Rep.
- Posts: 1324
- Joined: Sun. Mar. 09, 2008 11:18 am
- Location: Loysburg, PA
- Stoker Coal Boiler: Several EFM 520 refurbs...one 900, one 1300 mega-stoker
- Hand Fed Coal Stove: (2) Warm Morning Stoves
Sulphur deposits.
Sulphur comes in contact with moisture and that’s what is left when it dries.
Sulphur comes in contact with moisture and that’s what is left when it dries.
- coaledsweat
- Site Moderator
- Posts: 13766
- Joined: Fri. Oct. 27, 2006 2:05 pm
- Location: Guilford, Connecticut
- Stoker Coal Boiler: Axeman Anderson 260M
- Coal Size/Type: Pea
Whatever you call them, they'll be holes in a year or two.
-
- Member
- Posts: 6515
- Joined: Sun. Feb. 10, 2008 3:48 pm
- Location: Cape Cod, MA
- Stoker Coal Boiler: want AA130
- Hand Fed Coal Stove: DS Machine BS#4, Harman MKII, Hitzer 503,...
- Coal Size/Type: Pea/Nut/Stove
Pipe gets like tinfoil...
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
Happens even to SS Chimney Liners but isn't visible because it's out of sight...take note.