Jotul 507 Test

 
User avatar
Freddy
Member
Posts: 7293
Joined: Fri. Apr. 11, 2008 2:54 pm
Location: Orrington, Maine
Stoker Coal Boiler: Axeman Anderson 130 (pea)
Coal Size/Type: Pea size, Superior, deep mined

Post by Freddy » Fri. Sep. 18, 2009 4:02 pm

I'm planning on firing a Jotul 507 for the first time since new gaskets & bricks. I'm hoping to set it outside with an elbow & 6 or 7 feet of stove pipe sticking up. Will that be OK? Anything else I should do besides throw in the match?


 
User avatar
Poconoeagle
Member
Posts: 6397
Joined: Sat. Nov. 08, 2008 7:26 pm
Location: Tobyhanna PA

Post by Poconoeagle » Fri. Sep. 18, 2009 4:55 pm

They are too good a stove to fire.... you should keep it working and feed it fossil fuel... :D :lol: 8-)

 
User avatar
Freddy
Member
Posts: 7293
Joined: Fri. Apr. 11, 2008 2:54 pm
Location: Orrington, Maine
Stoker Coal Boiler: Axeman Anderson 130 (pea)
Coal Size/Type: Pea size, Superior, deep mined

Post by Freddy » Fri. Sep. 18, 2009 7:24 pm

Har Har Har *SLAP!* Now get back to work! :)

 
User avatar
the snowman
Member
Posts: 611
Joined: Mon. Sep. 29, 2008 10:38 pm
Location: upstate NY Tug Hill area
Hand Fed Coal Stove: Jotul 507
Coal Size/Type: Nut, Stove coal, Egg coal

Post by the snowman » Sun. Sep. 20, 2009 10:45 am

Freddy:

The manual calls for a minimum 10 ft chimney and six inch diameter pipe, however, if your going to just test fire it, six or seven feet of chimney pipe should work just fine. Post some pics and let us know how it works. Where did you get the bricks from. Can you take some pics of your brick?

The snowman.

 
User avatar
Freddy
Member
Posts: 7293
Joined: Fri. Apr. 11, 2008 2:54 pm
Location: Orrington, Maine
Stoker Coal Boiler: Axeman Anderson 130 (pea)
Coal Size/Type: Pea size, Superior, deep mined

Post by Freddy » Sun. Sep. 20, 2009 1:30 pm

Here's a pic of the test run. I lit it this morning a 7AM. Half filled it with nut & set it on "1 1/2". Using my laser thermometer to see temp, it's been 250-275 degrees for the last 6 1/2 hours. Looks like it'll still be going this evening.

The original brick isn't bad....also isn't good, but it'll go another season I'm sure. The brick I put in was to replace the cast iron liners that go above the brick. I notched the bricks with a diamond blade in my skill saw & glued them with furnace cement. Here's a pic of the first row. The stove in the pic also has another row above these. The top ones were trickier to cut to shape, but they fit just fine. I used common firebrick that I got for $2 a brick at the local brickyard. They call them "half bricks". The stove shop gets $5 each!

Attachments

Jotul test (1).JPG
.JPG | 155.6KB | Jotul test (1).JPG
Jotul test.JPG
.JPG | 145.9KB | Jotul test.JPG

 
User avatar
009to090
Member
Posts: 5104
Joined: Fri. Jan. 30, 2009 10:02 am
Location: Live Oak, FL

Post by 009to090 » Sun. Sep. 20, 2009 1:43 pm

Freddy wrote:Here's a pic of the test run. I lit it this morning a 7AM.
I used common firebrick that I got for $2 a brick at the local brickyard. They call them "half bricks". The stove shop gets $5 each!
Looks good Freddy, but why did you set it up at the end of your driveway? I'm concerned your mailman might mistake it for a mail box :shock: :woot: :doh: :mad3:
TSC has firebrick for $2.00 ea. Our TSC keeps a full pallet of them near the front of the store.

 
rberq
Member
Posts: 6445
Joined: Mon. Apr. 16, 2007 9:34 pm
Location: Central Maine
Hand Fed Coal Stove: DS Machine 1300 with hopper
Coal Size/Type: Blaschak Anthracite Nut
Other Heating: Oil hot water radiators (fuel oil); propane

Post by rberq » Sun. Sep. 20, 2009 3:40 pm

Freddy wrote:Here's a pic of the test run. I lit it this morning a 7AM.
Must be a good stove. I noticed the temperature here begin to rise almost immediately.


 
User avatar
Freddy
Member
Posts: 7293
Joined: Fri. Apr. 11, 2008 2:54 pm
Location: Orrington, Maine
Stoker Coal Boiler: Axeman Anderson 130 (pea)
Coal Size/Type: Pea size, Superior, deep mined

Post by Freddy » Sun. Sep. 20, 2009 5:07 pm

DVC500 at last wrote:your mailman might mistake it for a mail box
I was thinking that same thing, but ya know, checks always come on Saturday so you can't cash them until Monday, but tomorrow being Monday, only bills come. I'm hoping for the mailman mistake. ;)
rberq wrote:I noticed the temperature here begin to rise almost immediately
Just after it got going I mentioned to the wife that the frost was starting to melt from the roof. :)

5:07PM The 507 is still at 265*.

 
User avatar
Freddy
Member
Posts: 7293
Joined: Fri. Apr. 11, 2008 2:54 pm
Location: Orrington, Maine
Stoker Coal Boiler: Axeman Anderson 130 (pea)
Coal Size/Type: Pea size, Superior, deep mined

Post by Freddy » Sun. Sep. 20, 2009 6:54 pm

7PM. 350* Not much left now, but I'll bet a few more hours of heat. It's getting chilly out. It's nice to stand near it!

Attachments

Jotul Fire test.JPG
.JPG | 142.1KB | Jotul Fire test.JPG

 
User avatar
009to090
Member
Posts: 5104
Joined: Fri. Jan. 30, 2009 10:02 am
Location: Live Oak, FL

Post by 009to090 » Sun. Sep. 20, 2009 7:04 pm

Freddy wrote:7PM. 350* Not much left now, but I'll bet a few more hours of heat. It's getting chilly out. It's nice to stand near it!
Got any marshmellows?? :D

 
User avatar
Scottscoaled
Member
Posts: 2812
Joined: Tue. Jan. 08, 2008 9:51 pm
Location: Malta N.Y.
Stoker Coal Boiler: EFM 520, 700, Van Wert 800 GJ 61,53
Baseburners & Antiques: Magic Stewart 16, times 2!
Coal Size/Type: Lots of buck
Other Heating: Slant Fin electric boiler backup

Post by Scottscoaled » Sun. Sep. 20, 2009 9:24 pm

Freddy wrote:7PM. 350* Not much left now, but I'll bet a few more hours of heat. It's getting chilly out. It's nice to stand near it!
Jotul Chiminea,,,,,,,hmmmmmmmmmm. Nice Idea!

 
User avatar
the snowman
Member
Posts: 611
Joined: Mon. Sep. 29, 2008 10:38 pm
Location: upstate NY Tug Hill area
Hand Fed Coal Stove: Jotul 507
Coal Size/Type: Nut, Stove coal, Egg coal

Post by the snowman » Sun. Sep. 20, 2009 9:46 pm

Freddy:

Nice pics. I like the way you have the firebrick cut to fit in the stove. Good idea. Love the stove pipe combo you have going on. Probably in two weeks I will have the red Jotul hooked up and ready for a test fire. The wife is getting anxious to have the red one online before it really gets cold. We had another frost last night. It was a hard killing frost. I hope we get snow early again this year.

The snowman.

 
othillo
New Member
Posts: 1
Joined: Tue. Jan. 05, 2010 3:50 pm

Post by othillo » Tue. Jan. 05, 2010 3:55 pm

I have a Jotul 505 that would appear to be identical to the 507 with the addition of a smoke box/heat exchanger on the top. I have been searching for a manual and you mentioned that you have a manual for the 507, is there any way that you could post a link to a pdf?

How do you use the front vents for burning wood?

Such a great stove

Attachments

Jotul505.jpg
.JPG | 107.3KB | Jotul505.jpg

 
rberq
Member
Posts: 6445
Joined: Mon. Apr. 16, 2007 9:34 pm
Location: Central Maine
Hand Fed Coal Stove: DS Machine 1300 with hopper
Coal Size/Type: Blaschak Anthracite Nut
Other Heating: Oil hot water radiators (fuel oil); propane

Post by rberq » Tue. Jan. 05, 2010 6:23 pm

othillo wrote:I have a Jotul 505 that would appear to be identical to the 507 with the addition of a smoke box/heat exchanger on the top.
That's an interesting looking stove. Extra surface area for radiating heat. Would you post the dimensions? Height / width / depth of the stove, also dimensions of the firebox? Does it have shaker grates for burning coal?

 
User avatar
the snowman
Member
Posts: 611
Joined: Mon. Sep. 29, 2008 10:38 pm
Location: upstate NY Tug Hill area
Hand Fed Coal Stove: Jotul 507
Coal Size/Type: Nut, Stove coal, Egg coal

Post by the snowman » Wed. Jan. 06, 2010 10:23 pm

othillo:

Damn that is a nice stove. I want one of them! I believe I should have one of them in my growing collection. Did they come in any other colors? The lip under the ash door is a nice feature and I like the base. Do you have anymore pics of the stove you can post.

the snowman.


Post Reply

Return to “Imported Hand Fired Coal Stoves Using Anthracite”