HAAS+SOHN???

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 2:07 pm

So strange named after planets

ShawnLiNy · Post by **ShawnLiNy** » Wed. Nov. 08, 2023 3:27 pm

dilly358 wrote: ↑
Wed. Nov. 08, 2023 2:07 pm
So strange named after planets

looks like no parts are listed for this model , but look at the the parts lists from other models they likely used the same plates for whatever purpose

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 3:46 pm

Thanks since brand new never used is good should last years before need to find parts

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 3:46 pm

Coal is getting phased out soon too so I love heating with coal

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 4:51 pm

Also my dial on side goes up to 8 what is best setting

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 4:53 pm

Here's my dial

Post by **franco b** » Wed. Nov. 08, 2023 4:54 pm

dilly358 wrote: ↑
Wed. Nov. 08, 2023 4:51 pm
Also my dial on side goes up to 8 what is best setting

The best setting is when the air flap is closed or almost closed when the stove is at the temperature you want. Use a flashlight.

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 4:57 pm

Thanks the disc in where Ashland is on right side doesn't open much there's two holes on the round thing it only moves left to right a bit

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 4:58 pm

Doesn't open or move much with dial

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 5:00 pm

Here it is just moves a little left or right maybe opens a hair

Post by **franco b** » Wed. Nov. 08, 2023 5:04 pm

It should be moving away from stove surface to open. With a cold stove it should be wide open.

dilly358 · Post by **dilly358** » Wed. Nov. 08, 2023 5:08 pm

Yea only opens a hair or closes no matter how high or low on dial

Post by **franco b** » Wed. Nov. 08, 2023 5:24 pm

dilly358 wrote: ↑
Wed. Nov. 08, 2023 5:08 pm
Yea only opens a hair or closes no matter how high or low on dial

I don't think it is working right. I would pull the dial and remove the plate to get at and observe the operation and adjust as needed.

dilly358 · Post by **dilly358** » Fri. Nov. 10, 2023 9:47 am

Thanks so much for in put I spun the disk to the right a few spins from the bottom where Ashbin is now it opens and closes 8 is wide open and lower u go it closes

HAAS+SOHN???

Attachments

Attachments

Attachments