But my question is comparing same size bit and Anthracite, I.E. nut, is if I used in the past 3 tons of Anthracite, would I expect to us approximately the same amount of bit?
Bit Usage Compared to Anthracite
-
cntbill
- Member
- Posts: 330
- Joined: Thu. Nov. 12, 2009 1:00 pm
- Hot Air Coal Stoker Furnace: EFM AF-150
- Baseburners & Antiques: Radiant Gem 22 & Queen Bengal both by Floyd, Wells Co.
- Coal Size/Type: Rice / Buck - Nut and Stove
- Other Heating: Fireplace
- Location: Reading PA
- Contact:
I know from my reading here that there seems to be quite a quality difference of various bit along with the size as well. So maybe too vague of a question?
But my question is comparing same size bit and Anthracite, I.E. nut, is if I used in the past 3 tons of Anthracite, would I expect to us approximately the same amount of bit?
But my question is comparing same size bit and Anthracite, I.E. nut, is if I used in the past 3 tons of Anthracite, would I expect to us approximately the same amount of bit?
-
franco b
- Site Moderator
- Posts: 9287
- Joined: Wed. Nov. 05, 2008 5:11 pm
- Hand Fed Coal Stove: V ermont Castings 2310, Franco Belge 262
- Baseburners & Antiques: Glenwood Modern Oak 114
- Coal Size/Type: nut and pea
- Location: Kent CT
You would use more bit because that smoke not burned is good fuel.
Both fuels if air starved produce CO, so that is probably a draw.
If you burn it in the Florence it depends on how clean it burns.
Both fuels if air starved produce CO, so that is probably a draw.
If you burn it in the Florence it depends on how clean it burns.
-
cntbill
- Member
- Posts: 330
- Joined: Thu. Nov. 12, 2009 1:00 pm
- Hot Air Coal Stoker Furnace: EFM AF-150
- Baseburners & Antiques: Radiant Gem 22 & Queen Bengal both by Floyd, Wells Co.
- Coal Size/Type: Rice / Buck - Nut and Stove
- Other Heating: Fireplace
- Location: Reading PA
- Contact:
So really even if you go by BTU's per lb. there is just too many variables to make a good guess...franco b wrote:You would use more bit because that smoke not burned is good fuel.
Both fuels if air starved produce CO, so that is probably a draw.
If you burn it in the Florence it depends on how clean it burns.
Thanks !
-
dbsuz05
- Member
- Posts: 36
- Joined: Thu. Nov. 28, 2013 8:09 am
- Stove/Furnace Make: Burnham
- Stove/Furnace Model: 23"
I burn bit coal, in a 1920’s boiler. It was made for that. I have burned anthracite in it also. My findings on them.. ant. Will burn you out of the house! And seems like heat is wasted. Instead of a long low slow burn like bit. Bit is half the price. And keeps me warm but not too warm! So I’m all for bit! Ps. Bit will always be a cranky fuel you just have to get used to the fluctuations with fines and stuff. Ant is always perfect chunks and ultimately reliable burning characteristics.
-
cntbill
- Member
- Posts: 330
- Joined: Thu. Nov. 12, 2009 1:00 pm
- Hot Air Coal Stoker Furnace: EFM AF-150
- Baseburners & Antiques: Radiant Gem 22 & Queen Bengal both by Floyd, Wells Co.
- Coal Size/Type: Rice / Buck - Nut and Stove
- Other Heating: Fireplace
- Location: Reading PA
- Contact:
dbsuz05,
Hey thanks for your response, but since last year when I posted the original question, I did try some bit in the Warm Morning, like your Burnham it was designed for it and worked very well and was a good learning experience for me. Only problem just a little too much smoke and odor for the neighborhood I am in as I didn't want the neighbors knocking on my door, so I use Ant for the season and that worked out very well in the Warm Morning as well. But this year I am in the process of setting up a EFM A-150. And again thanks for your response
Hey thanks for your response, but since last year when I posted the original question, I did try some bit in the Warm Morning, like your Burnham it was designed for it and worked very well and was a good learning experience for me. Only problem just a little too much smoke and odor for the neighborhood I am in as I didn't want the neighbors knocking on my door, so I use Ant for the season and that worked out very well in the Warm Morning as well. But this year I am in the process of setting up a EFM A-150. And again thanks for your response
-
lsayre
- Member
- Posts: 14868
- Joined: Wed. Nov. 23, 2005 9:17 pm
- Stoker Coal Boiler: AHS S130 Coal Gun
- Coal Size/Type: Blaschak Anthracite Pea
- Other Heating: Resistance Boiler (13.5 KW), ComfortMax 75
- Location: N/E Ohio, between Medina and Wadsworth
Some bituminous coal has more BTU's per lb. than anthracite. Less ash also.