Cleanout Lever on EFM 520

Stoker Coal Boilers automatically feed the coal and have controls and pumps just like any conventions boiler. They are intended to be used as a primary heat and often have domestic hot water coils as an added bonus. They can be set up independently or in dual sytem with your existing oil/gas boiler. They can accommodate both hot water base board or steam plumbing.
Post Reply
IceDog
Member
Posts: 33
Joined: Wed. May. 28, 2008 10:41 am
Stove/Furnace Make: EFM 520
Stove/Furnace Model: Yellow Flame (Hot Water Oil)
Location: Andreas, PA

Post Tue. Jul. 22, 2008 1:44 pm

I notice if I remove the sheet metal cover allowing access to the blower, and cam arm for the worm feed, I can pull the cleanout lever further than if I have the sheet metal cover on. The lever hits the sheet meal cover and stops the lever from about 1 to 2 inches short of full range.

Is this OK? I'm new to this and I want to make sure I am redirecting the air to properly clean the fines from the burn pot.

Thanks for any input.

Snowdog

Visit Alternate Heating Sytems

User avatar
stoker-man
Verified Business Rep.
Posts: 2063
Joined: Mon. Nov. 19, 2007 9:33 pm
Hand Fed Coal Boiler: 1981 efm wcb-24 in use 365 days a year
Coal Size/Type: Anthracite/Chestnut
Other Heating: Hearthstone wood stove
Location: Lehigh Valley, PA

Post Tue. Jul. 22, 2008 2:44 pm

Check your PMs
‹(•¿•)›

Post Reply

Return to “Stoker Coal Boilers Using Anthracite (Hydronic and Steam)”