low water cutoff
-
BodyshopPat
- Member
- Posts: 65
- Joined: Mon. Jan. 01, 2018 10:42 am
- Stoker Coal Boiler: S260 COALGUN-(thanks Dave1234)
- Hand Fed Coal Boiler: New Yorker WC-130/on rice/80gal storage
- Hand Fed Coal Stove: THERMO-PRIDE WC 27-- 1980 MODEL
- Hand Fed Coal Furnace: modified CLAYTON 1802G WITH STAINLESS COILS
- Coal Size/Type: PEA AND RICE -LUMP SLACK AND VARIOUS SIZES OF BITUMINOUS
- Other Heating: RINNAI TANKLESS LP - AND HEAT PUMP
all you guys out there with ahs coal guns, what type and model number of low water cut off are you using? I don't have one now in my system and wanted to add one with the new install when it arrives. As always your thoughts are appreciated. Pat
-
lzaharis
- Member
- Posts: 2378
- Joined: Sun. Mar. 25, 2007 8:41 pm
- Location: Ithaca, New York
- Stoker Coal Boiler: Keystoker KAA-4-1 dual fuel boiler
- Hand Fed Coal Boiler: former switzer CWW100-sold
- Coal Size/Type: rice
- Other Heating: kerosene for dual fuel Keystoker/unused
This model will work for any boiler; If you purchase a B+G RB-122-E it is a direct water contact low water cut off which is the immersion type of low water cut off it will work very well for you.
If you wire it as the first control for the boiler and then run the the feeder wire to the controls you will be sure to have a control that will shut the boiler off as the first control ahead of the other boiler controls and it will not affect the operation of the boiler.
If you wire it as the first control for the boiler and then run the the feeder wire to the controls you will be sure to have a control that will shut the boiler off as the first control ahead of the other boiler controls and it will not affect the operation of the boiler.
