Fire issues.
-
- New Member
- Posts: 1
- Joined: Mon. Sep. 03, 2018 6:47 pm
- Stoker Coal Boiler: EFM
- Coal Size/Type: Rice Coal
The furnace guys have been here 2 times. First time they did patch work to repair draft. 2nd time they replaced pieces of pipe. They tested timer said it was good. Fire lasted 4 days went out again. Restarted fire only lasted a few hours. There is no setting to adjust draft. Any ideas on why it keeps doing this?
- StokerDon
- Site Moderator
- Posts: 7502
- Joined: Mon. Nov. 11, 2013 11:17 am
- Location: PA, Southern York County!
- Stoker Coal Boiler: Gentleman Janitor GJ-5, Van Wert VA-600, Axeman Anderson130 X3.
- Hand Fed Coal Furnace: Harman SF3500 reduced down to 3 grates connected to its own plenum
- Coal Size/Type: Rice, Chestnut and whatever will fit through the door on the Harman
- Other Heating: Noth'in but COAL! Well, Maybe a little tiny bit of wood
Welcome to the Forum Cookie,
To help diagnose this, we will need to know your timer, feed rate and air settings, about how tall your chimney is and what it's made of. Pictures help too.
So, I'm guessing these furnace guys said the draft was to low? Did they measure it?
This is pretty common in warm weather but there are a few tricks you can use to keep it going.
-Don
To help diagnose this, we will need to know your timer, feed rate and air settings, about how tall your chimney is and what it's made of. Pictures help too.
So, I'm guessing these furnace guys said the draft was to low? Did they measure it?
This is pretty common in warm weather but there are a few tricks you can use to keep it going.
-Don
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
Who gets called to do the routine service work when there isn't an "out-fire"?Cookieluv0105 wrote: ↑Mon. Sep. 03, 2018 6:53 pmThe furnace guys have been here 2 times. First time they did patch work to repair draft. 2nd time they replaced pieces of pipe. They tested timer said it was good. Fire lasted 4 days went out again. Restarted fire only lasted a few hours. There is no setting to adjust draft. Any ideas on why it keeps doing this?
Routine work needs done regularly too.
When was the last cleaning and inspections done?
Burn rings conditions in fire-pot needs to be know each season to be good for best continued fire operation.