EFM Oil Pan Screw Needed

Post Reply
ben
Member
Posts: 85
Joined: Thu. Aug. 06, 2009 9:06 pm
Stoker Coal Boiler: EFM 350 with an S-20 pot (1966)
Coal Size/Type: Rice
Location: n central PA

Post Wed. Feb. 05, 2014 4:06 pm

The other day when I was cleaning my unit I dicided to change out my oil from the pan that holds a small amount visible oil. I think its thick gear oil in this pan.
While doing this I lost 1 of the screws. It looks like a machine type screw. The pan is supported by two screws. Somehow it got sucked up im my shop vac or something. Anyways it's lost. I need 1 any advise ?
I'm a funeral director not a plumber,--- but I do a good job of cleaning and maintaining my unit.

Thanks

franco b
Site Moderator
Posts: 8570
Joined: Wed. Nov. 05, 2008 5:11 pm
Hand Fed Coal Stove: V ermont Castings 2310, Franco Belge 262
Baseburners & Antiques: Glenwood Modern Oak 114
Coal Size/Type: nut and pea
Location: Kent CT

Post Wed. Feb. 05, 2014 4:10 pm

Just take the remaining screw to the hardware store to match up.

Visit Alternate Heating Sytems

scrapper_23jr
Verified Business Rep.
Posts: 124
Joined: Mon. Mar. 10, 2008 10:45 am
Location: Pine Grove, PA

Post Wed. Feb. 05, 2014 5:22 pm

A FIVE SIXTEENTH BY THREE QUARTER COURSE THREAD BOLT WILL DO THE JOB NOTHING SPECIAL ABOUT THE THREAD scrapper

ben
Member
Posts: 85
Joined: Thu. Aug. 06, 2009 9:06 pm
Stoker Coal Boiler: EFM 350 with an S-20 pot (1966)
Coal Size/Type: Rice
Location: n central PA

Post Wed. Feb. 05, 2014 6:35 pm

thanks a lot

Post Reply

Return to “Stoker Coal Boilers Using Anthracite (Hydronic & Steam)”