Yes, I have been dripping 2-3 drops to fill those up every month or two.
I used to work at a place that had 100 yr old machines with cams and followers that ran 120+ hours a week,
all oil points (100+) were oiled every shift at 8 hours, some even during being ran.
I will be ordering a backup this week, just have to match up numbers n stuff.
Must have stop/started over 100 times this weekend, so I am stumped as to wth was the problem.
My only guess is maybe something in that gear diff box was hanging something up or ?
520 Stoker Motor Tripping Out
- GoodProphets
- Member
- Posts: 226
- Joined: Sat. Jan. 07, 2012 9:14 pm
- Location: Lanc Co PA
- Stoker Coal Boiler: EFM DF520
- Coal Size/Type: Anthra Rice
- Other Heating: 3 Fireplaces
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
- GoodProphets
- Member
- Posts: 226
- Joined: Sat. Jan. 07, 2012 9:14 pm
- Location: Lanc Co PA
- Stoker Coal Boiler: EFM DF520
- Coal Size/Type: Anthra Rice
- Other Heating: 3 Fireplaces
I was looking at this one here
http://www.amazon.com/Marathon-O600-Frame-Burner- ... B0057YFD60
1/8 hp is what is on now, so this would be direct fit, I just have to match numbers
http://www.amazon.com/Marathon-O600-Frame-Burner- ... B0057YFD60
1/8 hp is what is on now, so this would be direct fit, I just have to match numbers
- Rob R.
- Site Moderator
- Posts: 18009
- Joined: Fri. Dec. 28, 2007 4:26 pm
- Location: Chazy, NY
- Stoker Coal Boiler: EFM 520
- Hand Fed Coal Stove: Chubby Jr
You want model 4782, not O600. The 4782 motor is fully enclosed, and I have one running beautifully on my 520.
Also, a 1/6 (even 1/4 and 1/3) HP motor will bolt on with no issues...but in my experience the 1/8 HP motors are usually the most quiet at startup and the least expensive. Even a 56N frame motor will fit...I have one on my brothers 520; it was new old stock and $50 to the door. Made in USA also.
Also, a 1/6 (even 1/4 and 1/3) HP motor will bolt on with no issues...but in my experience the 1/8 HP motors are usually the most quiet at startup and the least expensive. Even a 56N frame motor will fit...I have one on my brothers 520; it was new old stock and $50 to the door. Made in USA also.