Auger Bushing Change

Stoker Coal Boilers automatically feed the coal and have controls and pumps just like any conventions boiler. They are intended to be used as a primary heat and often have domestic hot water coils as an added bonus. They can be set up independently or in dual sytem with your existing oil/gas boiler. They can accommodate both hot water base board or steam plumbing.
Post Reply
Catwood
New Member
Posts: 4
Joined: Sun. Oct. 21, 2012 3:04 pm
Stove/Furnace Make: EFM
Stove/Furnace Model: 350
Location: North River, N.Y.

Post Fri. Oct. 26, 2012 9:31 pm

Anybody with suggestions on changing the auger bushings in EFM 350 , any ideas greatly appreciated. John

Visit Alternate Heating Sytems

User avatar
Rob R.
Site Moderator
Posts: 11348
Joined: Fri. Dec. 28, 2007 4:26 pm
Stoker Coal Boiler: EFM DF520
Hand Fed Coal Stove: Hitzer 50-93
Coal Size/Type: Lehigh Rice
Other Heating: Dad's 1953 EFM Highboy
Location: Chazy, NY

Post Fri. Oct. 26, 2012 9:46 pm

A piece of 1/2" black iron pipe should allow you to drive the bushing out of the pot housing. Put the new one in the same way. As long as you have the stoker on the bench, I could completely go through it and replace the auger (unless it was recently replaced). Check the fit & operation of the fines cleanout plate, the wedges might need to be adjusted.

Post Reply

Return to “Stoker Coal Boilers Using Anthracite (Hydronic and Steam)”