Trouble Removing Coupler From EFM Worm

Stoker Coal Boilers automatically feed the coal and have controls and pumps just like any conventions boiler. They are intended to be used as a primary heat and often have domestic hot water coils as an added bonus. They can be set up independently or in dual sytem with your existing oil/gas boiler. They can accommodate both hot water base board or steam plumbing.
Post Reply
maverick784
New Member
Posts: 18
Joined: Wed. Oct. 10, 2012 10:38 pm
Stove/Furnace Make: EFM

Post Wed. Oct. 10, 2012 11:02 pm

Hello,

Having trouble removing the coupler from my EFM worm....I do know that the threads are left handed.....Does the coupler thread from both ends or is it permanently fastened on one end....Would heat help? looking for any ideas

Thanks in advanced,

JD

Visit Alternate Heating Sytems

User avatar
Rob R.
Site Moderator
Posts: 11346
Joined: Fri. Dec. 28, 2007 4:26 pm
Stoker Coal Boiler: EFM DF520
Hand Fed Coal Stove: Hitzer 50-93
Coal Size/Type: Lehigh Rice
Other Heating: Dad's 1953 EFM Highboy
Location: Chazy, NY

Post Thu. Oct. 11, 2012 11:47 am

The coupler is threaded on both ends. Spray it with some penetrating fluid, and carefully give it a try with a pipe wrench.

Post Reply

Return to “Stoker Coal Boilers Using Anthracite (Hydronic and Steam)”