Page 15 of 21
Re: EFM 350
Posted: Sat. Oct. 20, 2012 8:50 am
by 009to090
Nice find, John! Zone #2?
Re: EFM 350
Posted: Sat. Oct. 20, 2012 9:22 am
by CoalHeat
Yep.
Re: EFM 350
Posted: Sat. Oct. 20, 2012 9:49 pm
by CoalHeat
Got some cleaning done today, and pressure tested it. I did find a leak from one of the bottom push nipples. Going to try JB Weld on it.
Re: EFM 350
Posted: Sun. Oct. 21, 2012 9:31 pm
by CoalHeat
I try not to do anything half-way, I realize a leak is a leak, JB Weld is not a permanent fix, and what the hell...if there is one leak there is the potential for more and I don't want to have to take this thing out after it is installed because it is pissing water on my kitchen floor...so...
Moving the unit into the house is no problem now, since I will assemble it a foot from it's new home.
Re: EFM 350
Posted: Thu. Oct. 25, 2012 8:19 pm
by CoalHeat
The places I have to travel to for new nipples! Doesn't anyone rebuild radiators anymore?
Re: EFM 350
Posted: Sun. Nov. 04, 2012 9:54 pm
by CoalHeat
Re: EFM 350
Posted: Thu. Nov. 08, 2012 2:29 pm
by JeepinPete
That is down right pretty there!
Re: EFM 350
Posted: Sat. Nov. 10, 2012 9:51 pm
by CoalHeat
Thanks. Should be painting the flip sides tomorrow. I'll have it installed just in time for spring.
Re: EFM 350
Posted: Sun. Dec. 09, 2012 10:01 pm
by CoalHeat
Slowly moving towards Hydronic heat.
Re: EFM 350
Posted: Sun. Dec. 09, 2012 11:27 pm
by JeepinPete
I didn't realize an ax was the proper tool for disassembling a radiator
Re: EFM 350
Posted: Mon. Dec. 10, 2012 9:31 am
by CoalHeat
And a rototiller!
Re: EFM 350
Posted: Mon. Dec. 10, 2012 9:53 am
by 009to090
John, I thought you were set up for Forced Hot air. Are these radiators for other sections of the house?
Re: EFM 350
Posted: Mon. Dec. 10, 2012 10:39 am
by CoalHeat
Yes, forced hot air right now. I'm collecting radiators for the eventual switch. I don't like hot air heat! I have the boiler so why not?
Re: EFM 350
Posted: Tue. Dec. 11, 2012 8:59 pm
by CoalHeat
Three more!
Slenderized 5 pass...nice!
Re: EFM 350
Posted: Mon. Dec. 17, 2012 10:12 pm
by CoalHeat