Stokerman L6006C

army5102 · Post by **army5102** » Tue. Feb. 17, 2009 2:58 pm

Stokerman: Can I wire the control directly to the stocker motor on the D520 or where is the best place to wire it in to Thanks Dan

army5102 · Post by **army5102** » Tue. Feb. 17, 2009 3:01 pm

I want it sence an out fire Dan

billw · Post by **billw** » Tue. Feb. 17, 2009 3:21 pm

If you go to the EFM website they have online manuals. http://www.efmheating.com/manuals.html On page 17 of the 520 manual it shows the wiring diagram for an L6006.
The manual is a pdf document. Sometimes it takes forever to open.

army5102 · Post by **army5102** » Tue. Feb. 17, 2009 6:45 pm

If I install the L0006c this way will it shut the coal feed down so the stocker wont run???

army5102 · Post by **army5102** » Tue. Feb. 17, 2009 6:47 pm

I have a hot water system with oil backup thanks Dan

Post by **stoker-man** » Tue. Feb. 17, 2009 7:12 pm

Yes that will shut down the stoker if the water temperature goes below a certain temperature, sensing an outfire. It's very easy to wire up if you look at the schematics in the manual.