Stokerman L6006C

Stoker Coal Boilers automatically feed the coal and have controls and pumps just like any conventions boiler. They are intended to be used as a primary heat and often have domestic hot water coils as an added bonus. They can be set up independently or in dual sytem with your existing oil/gas boiler. They can accommodate both hot water base board or steam plumbing.
Post Reply
army5102
Member
Posts: 21
Joined: Sat. Mar. 22, 2008 11:35 am
Stove/Furnace Make: EFM coal stocker
Stove/Furnace Model: DF520

Post Tue. Feb. 17, 2009 2:58 pm

Stokerman: Can I wire the control directly to the stocker motor on the D520 or where is the best place to wire it in to Thanks Dan

army5102
Member
Posts: 21
Joined: Sat. Mar. 22, 2008 11:35 am
Stove/Furnace Make: EFM coal stocker
Stove/Furnace Model: DF520

Post Tue. Feb. 17, 2009 3:01 pm

I want it sence an out fire Dan

User avatar
billw
Member
Posts: 1087
Joined: Mon. Apr. 24, 2006 5:40 pm
Stove/Furnace Make: EFM 520
Stove/Furnace Model: GOODBYE OIL COMPANY
Location: Dallas, PA

Post Tue. Feb. 17, 2009 3:21 pm

If you go to the EFM website they have online manuals. http://www.efmheating.com/manuals.html On page 17 of the 520 manual it shows the wiring diagram for an L6006.
The manual is a pdf document. Sometimes it takes forever to open.

Visit Alternate Heating Sytems

army5102
Member
Posts: 21
Joined: Sat. Mar. 22, 2008 11:35 am
Stove/Furnace Make: EFM coal stocker
Stove/Furnace Model: DF520

Post Tue. Feb. 17, 2009 6:45 pm

If I install the L0006c this way will it shut the coal feed down so the stocker wont run???

army5102
Member
Posts: 21
Joined: Sat. Mar. 22, 2008 11:35 am
Stove/Furnace Make: EFM coal stocker
Stove/Furnace Model: DF520

Post Tue. Feb. 17, 2009 6:47 pm

I have a hot water system with oil backup thanks Dan

User avatar
stoker-man
Verified Business Rep.
Posts: 2063
Joined: Mon. Nov. 19, 2007 9:33 pm
Hand Fed Coal Boiler: 1981 efm wcb-24 in use 365 days a year
Coal Size/Type: Anthracite/Chestnut
Other Heating: Hearthstone wood stove
Location: Lehigh Valley, PA

Post Tue. Feb. 17, 2009 7:12 pm

Yes that will shut down the stoker if the water temperature goes below a certain temperature, sensing an outfire. It's very easy to wire up if you look at the schematics in the manual.
‹(•¿•)›

Visit Alternate Heating Sytems

army5102
Member
Posts: 21
Joined: Sat. Mar. 22, 2008 11:35 am
Stove/Furnace Make: EFM coal stocker
Stove/Furnace Model: DF520

Post Tue. Feb. 17, 2009 8:08 pm

Thank You Stockerman I will wire it tomarrow
where is the best place to strap it on being thas its a strap on sensor Dan

User avatar
stoker-man
Verified Business Rep.
Posts: 2063
Joined: Mon. Nov. 19, 2007 9:33 pm
Hand Fed Coal Boiler: 1981 efm wcb-24 in use 365 days a year
Coal Size/Type: Anthracite/Chestnut
Other Heating: Hearthstone wood stove
Location: Lehigh Valley, PA

Post Tue. Feb. 17, 2009 9:32 pm

I'd put it somewhere close to where the supply pipe comes out of the boiler.
‹(•¿•)›

army5102
Member
Posts: 21
Joined: Sat. Mar. 22, 2008 11:35 am
Stove/Furnace Make: EFM coal stocker
Stove/Furnace Model: DF520

Post Tue. Feb. 17, 2009 9:55 pm

Thank You stockerman for your advise Dan

Mark (PA)
Member
Posts: 383
Joined: Thu. Feb. 28, 2008 9:40 am
Stove/Furnace Make: 1953 EFM SF-520 High Boy
Stove/Furnace Model: Fitzgibbon Boiler
Location: South Central, PA

Post Wed. Feb. 18, 2009 8:39 pm

Dan

I am also using the C version and it is on the supply pipe about 2' from the outlet.

seems to work fine for me. Good luck with yours.

Post Reply

Return to “Stoker Coal Boilers Using Anthracite (Hydronic and Steam)”