Ash on stove body also on Nickel trim

Post Reply
 
Den034071
Member
Posts: 907
Joined: Sat. Jun. 25, 2011 4:30 pm
Hand Fed Coal Stove: Hitzer, 3095

Post by Den034071 » Thu. May. 25, 2023 10:16 am

Asking the experts or Guys who restored a Parlor stove .How do you remove the surface rust .Some pics on the forum Look Like The Stove Was in The Ocean .Please reply .jack

 
User avatar
davidmcbeth3
Member
Posts: 8505
Joined: Sun. Jun. 14, 2009 2:31 pm
Coal Size/Type: nut/pea/anthra

Post by davidmcbeth3 » Thu. May. 25, 2023 11:28 am

Rust removal is generally done either by chemical or mechanical means.

Acids are generally the chemical method (phosphoric, HCl are 2 options for example)

Mechanical could be simple as sandpaper or grinder.

Each has pros and cons. Very situation or case by case dependent.

 
User avatar
Sunny Boy
Member
Posts: 25560
Joined: Mon. Nov. 11, 2013 1:40 pm
Location: Central NY
Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
Coal Size/Type: Nuts !
Other Heating: Oil &electric plenum furnace

Post by Sunny Boy » Thu. May. 25, 2023 12:41 pm

Den034071 wrote:
Thu. May. 25, 2023 10:16 am
Asking the experts or Guys who restored a Parlor stove .How do you remove the surface rust .Some pics on the forum Look Like The Stove Was in The Ocean .Please reply .jack
For cast iron, sandblasting is a common way used by many of the restoration shops. It gets down into rust pits where sanding/grinding/wire wheel can't. Grinding removes good metal just to get down into the pits of heavily rusted metal.

You might find a sandblasting operation nearby.

Paul


 
User avatar
freetown fred
Member
Posts: 30293
Joined: Thu. Dec. 31, 2009 12:33 pm
Location: Freetown,NY 13803
Hand Fed Coal Stove: HITZER 50-93
Coal Size/Type: BLASCHAK Nut

Post by freetown fred » Thu. May. 25, 2023 12:51 pm

A big plus 1 on the sandblasting Jack. :)

 
User avatar
mntbugy
Member
Posts: 2042
Joined: Fri. Dec. 23, 2016 2:36 pm
Location: clearfield,pa
Hand Fed Coal Stove: D S 1500, Warm Moring 400
Baseburners & Antiques: Art Garland 145,GW114 ,Clarion 115, Vestal 20 Globe,New Royal22 Globe, Red Cross Oak 56,Acme Ventiduct 38,Radiant Airblast 626,Home Airblast 62,Moores #7,Moores 3way
Coal Size/Type: stove and nut and some bit
Other Heating: Propain

Post by mntbugy » Thu. May. 25, 2023 1:05 pm

For rust freckles. Miracle water soak then 0000 steel wool or s.o.s. pads.

Moon creators, sandblasting then belt sander then buffing wheel then plating.

Plating is the biggest expense.
About $700ish for an oak stove.
About $1000 and UP for mica baseburner.

Post Reply

Return to “Antiques, Baseburners, Kitchen Stoves, Restorations & Modern Reproductions”