antique range with electric conversion
subject: antique range, having an electric conversion done
Does anyone have any experience with electric conversions?
It is my understanding that electric conversions does not modify the integrity of the range, and the range could be reverted to coal once a flue installed. Is this correct? ... I am keen on this question, because someday when we renovate the kitchen, would like to have a flue/chimney installed and operate it with coal
We have a modern electric stove now, and there is very little to do besides tell it what temperature you want to bake at, and set a timer.
How would cooking with an antique range with electric elements change the cooking process?
I think we need to get some sort of remote thermostat to put inside the oven to monitor the temperature, if such a thing exists.
Modern stoves, the outer shell is insulated from the oven? whereas an antique range there outer shell is the oven, so it will be nearly the same temperature as the internal oven?
How would the cook top function? are the round inserts replaced by electric elements?
Where would the electric elements' controls go on an antique range?
Does anyone have any experience with electric conversions?
It is my understanding that electric conversions does not modify the integrity of the range, and the range could be reverted to coal once a flue installed. Is this correct? ... I am keen on this question, because someday when we renovate the kitchen, would like to have a flue/chimney installed and operate it with coal
We have a modern electric stove now, and there is very little to do besides tell it what temperature you want to bake at, and set a timer.
How would cooking with an antique range with electric elements change the cooking process?
I think we need to get some sort of remote thermostat to put inside the oven to monitor the temperature, if such a thing exists.
Modern stoves, the outer shell is insulated from the oven? whereas an antique range there outer shell is the oven, so it will be nearly the same temperature as the internal oven?
How would the cook top function? are the round inserts replaced by electric elements?
Where would the electric elements' controls go on an antique range?
- Sunny Boy
- Member
- Posts: 25707
- Joined: Mon. Nov. 11, 2013 1:40 pm
- Location: Central NY
- Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
- Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
- Coal Size/Type: Nuts !
- Other Heating: Oil &electric plenum furnace
Some of the conversions (electric or gas) that I've seen don't look like it would be easy to convert back because the control dials are mounted in behind the firebox door and the cook top surface is changed. Might be able to if the original parts were still available ?
Stove Hospital, and Stanley Iron Works could tell you more about it because they've done conversions.
http://stovehospital.com/
https://www.antiquestovesbystanleyiron.com/
Paul
Stove Hospital, and Stanley Iron Works could tell you more about it because they've done conversions.
http://stovehospital.com/
https://www.antiquestovesbystanleyiron.com/
Paul
-
- Member
- Posts: 771
- Joined: Sun. Jan. 18, 2015 9:40 pm
- Location: plainfield NH
- Hand Fed Coal Furnace: newmac wood,coal,oil como
- Baseburners & Antiques: 20th century laurel, glenwood hickory,crawford fairy
- Coal Size/Type: nut, stove
- Contact:
Check out Stanley iron works too, the ones I have seen as Paul mentioned have a new cooktop installed and they insulate the flues where the gases and smoke would travel otherwise the outside of the stove would be as hot as the inside and at that point you might as well just run coal year round like Paul... haha
- Sunny Boy
- Member
- Posts: 25707
- Joined: Mon. Nov. 11, 2013 1:40 pm
- Location: Central NY
- Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
- Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
- Coal Size/Type: Nuts !
- Other Heating: Oil &electric plenum furnace
Yup, woke up to 40F outside this morning, plus windy and damp. Heat from that range is sure nice !!!!!
Paul
-
- Member
- Posts: 771
- Joined: Sun. Jan. 18, 2015 9:40 pm
- Location: plainfield NH
- Hand Fed Coal Furnace: newmac wood,coal,oil como
- Baseburners & Antiques: 20th century laurel, glenwood hickory,crawford fairy
- Coal Size/Type: nut, stove
- Contact:
I hear ya, 45 this morning, had the new Atlantic going, till around noon, then fired it back up for dinner time, 50 now and 72 indoors. I sure do like this ol girl
-
- Member
- Posts: 8601
- Joined: Sat. May. 24, 2008 4:26 pm
- Location: Chester, NY
- Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
- Hand Fed Coal Stove: Invader 2
- Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
- Coal Size/Type: Rice,
- Other Heating: Heating Oil CH, Toyotomi OM 22
A serious question. Should the bastardization of a coal stove be made a capital offense?
- Sunny Boy
- Member
- Posts: 25707
- Joined: Mon. Nov. 11, 2013 1:40 pm
- Location: Central NY
- Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
- Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
- Coal Size/Type: Nuts !
- Other Heating: Oil &electric plenum furnace
I'm not sure putting replies all in capital letters is enough punishment.
Paul
Paul
-
- Member
- Posts: 8601
- Joined: Sat. May. 24, 2008 4:26 pm
- Location: Chester, NY
- Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
- Hand Fed Coal Stove: Invader 2
- Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
- Coal Size/Type: Rice,
- Other Heating: Heating Oil CH, Toyotomi OM 22
I was thinking hung, drawn and quartered but I can be extreme.capital offense. A crime, such as murder or betrayal of one's country, that is treated so seriously that death may be considered an appropriate punishment.
coalnewbie wrote: A serious question. Should the bastardization of a coal stove be made a capital offense?
Sunny Boy wrote: I'm not sure putting replies all in capital letters is enough punishment.
have mercy please , a range used as electric cooker would only be a temporary use , besides basement fireplace will have an antique insert burning coal sooncoalnewbie wrote: I was thinking hung, drawn and quartered but I can be extreme.
I talked with both Stanley Iron Works and Stove Hospital.
An electric conversion would permanently alter a range, due to the insulation that D.lapan mentioned and (if I understood correctly) something to do with the components that make up the new oven and electric element and how these are mounted.
If we do get a range, likely we put it in storage until we are ready to have a flue installed rather than have one converted. Just use our modern electric one until then. Brandon at Stove Hospital suggested that some ranges are worn or missing parts that they cannot be restored to solid fuel and would be candidates for conversion, so that is something we may consider.
An electric conversion would permanently alter a range, due to the insulation that D.lapan mentioned and (if I understood correctly) something to do with the components that make up the new oven and electric element and how these are mounted.
If we do get a range, likely we put it in storage until we are ready to have a flue installed rather than have one converted. Just use our modern electric one until then. Brandon at Stove Hospital suggested that some ranges are worn or missing parts that they cannot be restored to solid fuel and would be candidates for conversion, so that is something we may consider.
-
- Member
- Posts: 771
- Joined: Sun. Jan. 18, 2015 9:40 pm
- Location: plainfield NH
- Hand Fed Coal Furnace: newmac wood,coal,oil como
- Baseburners & Antiques: 20th century laurel, glenwood hickory,crawford fairy
- Coal Size/Type: nut, stove
- Contact:
I’m not sure where your located but I recently acquired a pile of cookstoves, I’ll give ya a hell of a deal restored or not as I could use the space
Ohio.
I am open to that.
I have been watching your "Cook stoves parlor stoves and parts" thread for pictures.
- Sunny Boy
- Member
- Posts: 25707
- Joined: Mon. Nov. 11, 2013 1:40 pm
- Location: Central NY
- Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
- Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
- Coal Size/Type: Nuts !
- Other Heating: Oil &electric plenum furnace
Good idea - convert a parts stove.
Plus, I'm pretty sure that would get you around that annoying "hung, drawn and quartered" problem.
Paul
Plus, I'm pretty sure that would get you around that annoying "hung, drawn and quartered" problem.
Paul
- warminmn
- Member
- Posts: 8185
- Joined: Tue. Feb. 08, 2011 5:59 pm
- Location: Land of 11,842 lakes
- Hand Fed Coal Stove: Chubby Junior, Riteway 37
- Coal Size/Type: nut and stove anthracite, lignite
- Other Heating: Wood and wear a wool shirt
There never would have been a hotrod car made or a car race without some bastardization occurring. I say go for it if thats what you want to do. Its your money. Spend it how you wish.... plus I hate being told what I "CAN'T" do Makes me want to do it myself now
I'll go hang myself now cuz CN's new Tesla he traded his Mustang for cant make it this far to do the job. I'll use a silk rope...
I'll go hang myself now cuz CN's new Tesla he traded his Mustang for cant make it this far to do the job. I'll use a silk rope...
- Pauliewog
- Member
- Posts: 1824
- Joined: Mon. Dec. 02, 2013 12:15 am
- Location: Pittston, Pennsylvania
- Hot Air Coal Stoker Furnace: Alaska 140 Dual Paddle Feed
- Baseburners & Antiques: Fame Rosemont #20, Home Stove Works #25, Glenwood #6, Happy Thought Oak, Merry Bride #214, Sunnyside, Worlds Argand #114, New Golden Sun , & About 30 others.
- Coal Size/Type: Stove, Chesnut, Pea, Rice / Anthracite
I think taking a non restorable stove, possibly one with a warped top and thrashed firebox, is a better option than converting a good restoration candidate.warminmn wrote: ↑Thu. Jun. 13, 2019 5:25 pmThere never would have been a hotrod car made or a car race without some bastardization occurring. I say go for it if thats what you want to do. Its your money. Spend it how you wish.... plus I hate being told what I "CAN'T" do Makes me want to do it myself now
I'll go hang myself now cuz CN's new Tesla he traded his Mustang for cant make it this far to do the job. I'll use a silk rope...
By no means am I a purist, in fact I'm guilty of quite a few unique car modifications in my day.
If I were a bit younger, I would love to pick up a lightly hit Tesla and throw in a nice big ICE drivetrain.
Paulie