Glenwood made the 2,3,4,5,oaks and a little later the 20,30,40,50 models. Many , but not all parts interchange. The grates are different. If you have a nice clean long bar you should have one made now and save the original as a pattern.
Firebrick. I use the plastic refractory type. It is easily molded to shape and you do not need to construct a form. It is available in 55 pound blocks sliced to two inch thick pieces. It is a much better material than the castable stuff
Looking for part diagram for Glenwood Oak No 3 1899
- Lydo
- New Member
- Posts: 19
- Joined: Fri. Sep. 21, 2018 3:35 pm
- Location: Quebec, Canada
- Baseburners & Antiques: Glenwood Oak No 3 1899
- Coal Size/Type: Anthracite rock
- Other Heating: Wood
Thank you for the info! Most appreciated!
Would you know where I could find/purchase these parts and the plastic refractory blocks? Hopefully somewhere close to Quebec Canada would be grate, if you just happen to know that is
I’ve been asking all the stove restauration places in Quebec and Ontario and still no luck.
Like you said, we might be better off having the parts remoulded.
Would you know where I could find/purchase these parts and the plastic refractory blocks? Hopefully somewhere close to Quebec Canada would be grate, if you just happen to know that is
I’ve been asking all the stove restauration places in Quebec and Ontario and still no luck.
Like you said, we might be better off having the parts remoulded.
-
- Member
- Posts: 267
- Joined: Sat. Jun. 25, 2011 7:00 pm
I have several Glenwood 30 oaks. They are very close to the #3. I do not recognize that flapper. The #30 has a sliding model that does a good job. I have had several cast and if you can't work with the one you have perhaps we can replace the back pipe with a 30
- Lydo
- New Member
- Posts: 19
- Joined: Fri. Sep. 21, 2018 3:35 pm
- Location: Quebec, Canada
- Baseburners & Antiques: Glenwood Oak No 3 1899
- Coal Size/Type: Anthracite rock
- Other Heating: Wood
It’s alive! We (my husband mostly) fixed the broken parts and I cleaned and refinished it and here it is! Thank you to all that help us through this project. Now if we can only find anthracite to burn in it. We’re burning wood now, only because we can’t find anthracite anywhere in Quebec. The only coal we can find is BBQ coal which is very expensive and burns too fast.
Anyways, we’re very proud of our stove.
Anyways, we’re very proud of our stove.