My 1884 Nay Aug Stove Works No. 10

Post Reply
 
User avatar
Vermont_Woodchuck
New Member
Posts: 5
Joined: Thu. Nov. 30, 2017 8:15 pm
Location: Vermont
Baseburners & Antiques: Nay Aug Stove Works No. 10

Post by Vermont_Woodchuck » Thu. Nov. 30, 2017 9:03 pm

My name is Chris. I'm new to Coalpail and new to coal. I live in a 300 square foot cabin in the woods in Vermont with no water and an outhouse. (But I do have 20 amp electrical service strung through the trees, and I do have wifi. I've got my priorities straight.)

I bought this stove for a dollar. It just needed some shining up and polishing, some new bolts, and some new mica. I re-cemented some joints and blinged it up with some fancy drawer pulls. I hand-formed a refractory liner.

The stove is 37 inches tall and 17 inches wide at the base. The cylinder itself is 10 inches in diameter, hence the model no. 10. The firepot is 12 inches from door to grate.

The stove is missing the finial. If anyone knows where I can find one, please let me know.

I've burned wood for any number of years, but I knew absolutely nothing about coal. Anything I now know I learned from these forums. So thank you for letting me lurk. So I figured I'd share my project with you. You all helped make this stove a success.

I burn nut coal with a two-inch layer of rice on top as a means of reducing draft. I shut down all manual drafts. I call this state "idling." At idle, this stove will put out a gentle heat that will keep my little cabin a nice and cozy 74 degrees at 32 degrees outside temperature. When colder outside, I increase the draft by reducing the rice coal layer on top, and even eliminate the rice coal layer entirely. I am quite convinced that this little stove will easily heat a 1000 square foot house. At idle, this stove will run for eighteen hours. To make things easy on myself, I shake down and reload every twelve hours. A forty-pound bag of coal lasts me two days.

So take a look at the pictures. Pat yourselves on the back because you folks all had a hand in making this beauty a functional appliance again. (Please forgive the lime green paint on the walls. I just moved in and the place is a work in progress.)

I'll never burn wood again, unless I have to.

Chris.
IMG_20171130_202128967.jpg
.JPG | 290.1KB | IMG_20171130_202128967.jpg
IMG_20171030_193244090-1.jpg
.JPG | 317.9KB | IMG_20171030_193244090-1.jpg
IMG_20171030_193300297.jpg
.JPG | 167.2KB | IMG_20171030_193300297.jpg
IMG_20171130_202505540.jpg
.JPG | 344.1KB | IMG_20171130_202505540.jpg

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Thu. Nov. 30, 2017 9:11 pm

Welcome to the world of coal and this board. The kettle IS the final who needs more. A closer pic of the inside and the back might help us to help you more. Many of us aspire to your lifestyle but lack the courage. :D

 
scalabro
Member
Posts: 4197
Joined: Wed. Oct. 03, 2012 9:53 am
Location: Western Massachusetts
Baseburners & Antiques: Crawford 40, PP Stewart No. 14, Abendroth Bros "Record 40"
Coal Size/Type: Stove / Anthracite.
Other Heating: Oil fired, forced hot air.

Post by scalabro » Thu. Nov. 30, 2017 9:14 pm

Welcome aboard Chris...nice job for $1 :lol:

 
franco b
Site Moderator
Posts: 11416
Joined: Wed. Nov. 05, 2008 5:11 pm
Location: Kent CT
Hand Fed Coal Stove: V ermont Castings 2310, Franco Belge 262
Baseburners & Antiques: Glenwood Modern Oak 114
Coal Size/Type: nut and pea

Post by franco b » Thu. Nov. 30, 2017 9:37 pm

Welcome to the forum.

Interesting and pretty little stove. Definitely need more pictures of back.

Tightening up the clinker and ash doors would give more control.


 
User avatar
michaelanthony
Member
Posts: 4550
Joined: Sat. Nov. 22, 2008 10:42 pm
Location: millinocket,me.
Hand Fed Coal Stove: Vigilant 2310, gold marc box stove
Hand Fed Coal Furnace: Gold Marc Independence
Baseburners & Antiques: Home Sparkle 12
Coal Size/Type: 'nut
Other Heating: Fujitsu mini split, FHA oil furnace

Post by michaelanthony » Thu. Nov. 30, 2017 9:39 pm

Very nice indeed VWC. CN is right about the finial, a cast iron pot makes a nice finial as well. Gotta' cook them critters in the woods too yah know. :yes:

 
User avatar
Vermont_Woodchuck
New Member
Posts: 5
Joined: Thu. Nov. 30, 2017 8:15 pm
Location: Vermont
Baseburners & Antiques: Nay Aug Stove Works No. 10

Post by Vermont_Woodchuck » Thu. Nov. 30, 2017 9:45 pm

franco b wrote:
Thu. Nov. 30, 2017 9:37 pm
Welcome to the forum.

Interesting and pretty little stove. Definitely need more pictures of back.

Tightening up the clinker and ash doors would give more control.
That was my first thought, trying to make it airtight. I put gasketing around all doors, but I still had way too much draft. I was burning myself out of the house. So I decided to pretend that it was 1884 all over again: I removed any gasketing and the doors are all loosie goosie now. If I need to reduce draft, I put a layer of rice on top (or char if I've run out of rice.) I've found it easier to control draft by impeding it from above rather than from below.

 
franco b
Site Moderator
Posts: 11416
Joined: Wed. Nov. 05, 2008 5:11 pm
Location: Kent CT
Hand Fed Coal Stove: V ermont Castings 2310, Franco Belge 262
Baseburners & Antiques: Glenwood Modern Oak 114
Coal Size/Type: nut and pea

Post by franco b » Thu. Nov. 30, 2017 9:51 pm

You might try a bead of silicone on the ash door, closed over some waxed paper until set.

 
User avatar
Vermont_Woodchuck
New Member
Posts: 5
Joined: Thu. Nov. 30, 2017 8:15 pm
Location: Vermont
Baseburners & Antiques: Nay Aug Stove Works No. 10

Post by Vermont_Woodchuck » Thu. Nov. 30, 2017 10:03 pm

coalnewbie wrote:
Thu. Nov. 30, 2017 9:11 pm
Welcome to the world of coal and this board. The kettle IS the final who needs more. A closer pic of the inside and the back might help us to help you more. Many of us aspire to your lifestyle but lack the courage. :D
I appreciate it, but it's not really a matter of courage. I used to be a properly functioning member of society but my life fell apart eight years ago, so I decided to screw it all. I've since learned what's important in this life: a little place to live, wildlife in the yard, ducks on the pond, and some good friends. I'm happier than ever.


 
User avatar
warminmn
Member
Posts: 8110
Joined: Tue. Feb. 08, 2011 5:59 pm
Location: Land of 11,842 lakes
Hand Fed Coal Stove: Chubby Junior, Efel Nestor Martin, Riteway 37
Coal Size/Type: nut and stove anthracite, lignite
Other Heating: Wood and wear a wool shirt

Post by warminmn » Thu. Nov. 30, 2017 10:56 pm

Vermont_Woodchuck wrote:
Thu. Nov. 30, 2017 10:03 pm
I appreciate it, but it's not really a matter of courage. I used to be a properly functioning member of society but my life fell apart eight years ago, so I decided to screw it all. I've since learned what's important in this life: a little place to live, wildlife in the yard, ducks on the pond, and some good friends. I'm happier than ever.
Aint that the truth! :clap:

I like how you just put rice on top to slow it down. I think I'd still want the bottom air tight but if its working, its working.

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Fri. Dec. 01, 2017 3:38 am

These stoves serve many purposes, yes iron pots work just as well. Who needs a finial? Lamb stew one day, potpourri the next ... I'm having so much fun with mine. :D

Attachments

100_0484.JPG
.JPG | 462.8KB | 100_0484.JPG

 
User avatar
Canaan coal man
Member
Posts: 822
Joined: Thu. Nov. 08, 2012 12:37 pm
Location: East Canaan, CT
Stoker Coal Boiler: Efm 520
Hand Fed Coal Stove: A little cubby coal stove in the basement
Baseburners & Antiques: Glenwood #6
Coal Size/Type: Stove And Nut

Post by Canaan coal man » Fri. Dec. 01, 2017 9:28 am

Can you imagine if he had a g109. With only 300sq ft. Talk about sipping coal.......

 
coalnewbie
Member
Posts: 8601
Joined: Sat. May. 24, 2008 4:26 pm
Location: Chester, NY
Hot Air Coal Stoker Stove: LL AnthraKing 180K, Pocono110K,KStokr 90K, DVC
Hand Fed Coal Stove: Invader 2
Baseburners & Antiques: Wings Best, Glenwood #8(x2) Herald 116x
Coal Size/Type: Rice,
Other Heating: Heating Oil CH, Toyotomi OM 22

Post by coalnewbie » Fri. Dec. 01, 2017 12:39 pm

Oh vw
I used to be a properly functioning member of society
here is the news of you, hot off the press. You are a properly functioning member of society. :)

Hmm cm, a 109 in that cabin - wow, A few more improperly functioning people like that and Matt could not make the payments on his luxury yacht.

Post Reply

Return to “Antiques, Baseburners, Kitchen Stoves, Restorations & Modern Reproductions”