Glenwood stoves etc .
I am just curious how do you remove get to the nuts an bolts of an Antiquestove when you disemble the stove .How to remove the skirts .How to remove the Wings are these two Hanging On a connector .Do you start tear down going through the feed door ..Please your help .jack from n0 9 mine in Penna.
- Sunny Boy
- Member
- Posts: 25726
- Joined: Mon. Nov. 11, 2013 1:40 pm
- Location: Central NY
- Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
- Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
- Coal Size/Type: Nuts !
- Other Heating: Oil &electric plenum furnace
The nickel-plated skirts and boot rails just lift off for polishing. The doors are "pintle and gudgeon" type hinges (like an old boat rudder). They just lift off.
The rest is held together with "stove bolts", which are just round head slotted machine screws and square nuts. No lock washers used.
The firepot, barrel, and top are bolted together. Then they just sit on the base frame without any fasteners.
The legs make up the corners of the base frame - sides and legs bolted together.
You can get new stove bolts and square nuts at many hardware stores or suppliers such as McMaster-Carr or Granger.
Paul
The rest is held together with "stove bolts", which are just round head slotted machine screws and square nuts. No lock washers used.
The firepot, barrel, and top are bolted together. Then they just sit on the base frame without any fasteners.
The legs make up the corners of the base frame - sides and legs bolted together.
You can get new stove bolts and square nuts at many hardware stores or suppliers such as McMaster-Carr or Granger.
Paul