Low heat value, or inefficient boiler.

 
User avatar
McGiever
Member
Posts: 10130
Joined: Sun. May. 02, 2010 11:26 pm
Location: Junction of PA-OH-WV
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hand Fed Coal Boiler: BUCKET A DAY water heater
Hand Fed Coal Stove: Warm Morning 414A
Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
Other Heating: Ground Source Heat Pump and some Solar

Post by McGiever » Mon. Jan. 28, 2019 1:08 pm

That all makes sense...nice that you were able to work this all out for yourself, I'm impressed. :)

 
franco b
Site Moderator
Posts: 11416
Joined: Wed. Nov. 05, 2008 5:11 pm
Location: Kent CT
Hand Fed Coal Stove: V ermont Castings 2310, Franco Belge 262
Baseburners & Antiques: Glenwood Modern Oak 114
Coal Size/Type: nut and pea

Post by franco b » Mon. Jan. 28, 2019 1:43 pm

Excellent reasoning. Just what is needed for better designs.

 
Bubbalowe
Member
Posts: 205
Joined: Fri. Sep. 08, 2017 12:54 pm
Hand Fed Coal Stove: Vigilant II 2310
Baseburners & Antiques: Grodin Petite
Other Heating: electric radiators until used boiler hook up

Post by Bubbalowe » Tue. Jan. 29, 2019 2:54 pm

Just read through and think the barrel boiler pretty cool. Barrel stoves pass heat faster than cast iron so think copper laying on tin should have good heat transfer? In my beer making hobby I've used immersion style wort chillers and counter flow chillers, same principle, to absorb heat. Something to consider is flow of water ie, slow flow down to allow more heat to be absorbed, 99C out being best. Measure water temperature into boiler, out of boiler, into house and back to boiler to get the most. Maybe just a gate valve inline for control?


 
DR ARNETT
New Member
Posts: 2
Joined: Mon. Nov. 19, 2018 2:24 am

Post by DR ARNETT » Sun. Apr. 07, 2019 8:14 pm

U MIGHT TRY ANTHROCITE NUT COAL FROM TRACTOR SUPPLY IF IT'S AVAIABLE WHERE U ARE I GET IT STARTED W/ WOOD THROW IN 'BOUT 30-40 LBS . ONCEIT GETS GOING BANK IT BACK IT SHOULD GO 6-8 HRS . MY HOME IS APRX. 400 FT SQ. I USE NATURAL DRAFT I DO HAVE A GRATE THOUGH. IF U CAN GET BIG CHUNKS OF BIT. COAL [ 10'' OR SO ] THAT WORKS BETTER.

 
User avatar
BigBarney
Member
Posts: 1853
Joined: Wed. Feb. 08, 2006 2:48 pm

Post by BigBarney » Tue. Apr. 09, 2019 4:35 pm

I like the way the grate looks but in reality the size is way overkill.

I guess 20" wide x 26" deep you have enough grate area for at least

200,000 btu of output , with descent coal. I believe grates this large

would be hard to shake even in three sections.

Typical grates of ~250 sq in get about 350 btu per sq in .,

so you have enough grate area for ~190,000 btu boiler .

At 20 watts per sq ft your home needs 4KW of heat or

~12,500 btu per hour on a 10* F day.

BigBarney

Post Reply

Return to “Hand Fired Coal Boilers & Hot Air Furnaces/Stoves Using Bituminous”