Type M Factory Setting

csstoker · Post by **csstoker** » Mon. Jan. 26, 2009 12:52 pm

does anyone know what the factory setting is for the Field Controls Type M baro?

WNY · Post by **WNY** » Mon. Jan. 26, 2009 1:15 pm

Did you look in the manual? It state 6-12" ones at factory set at .06

**Broken Link(s) Removed**

coal berner · Post by **coal berner** » Mon. Jan. 26, 2009 1:34 pm

csstoker wrote:does anyone know what the factory setting is for the Field Controls Type M baro?

You need either a Draft Rite gauge or a Manometer to find out what your chimney draft is first then adjust the weight screw in and out on the M baro until matches the gauge .04 to .05 is a good start for a hand fed stove if your using a stoker stove then try .02 over the fire and .04 for the stack pipe draft check the draft right at the flue on the stove some stoker stoves have a little hole in the viewing door or on front of the stove to check over the fire draft . The link below shows the manomenter you want to get .There is also a Manomenter lending Program on this forum contact Memeber Matthaus to get on the list .

http://www.dwyer-inst.com/PDF_files/mark2_iom.pdf

http://pdf.directindustry.com/pdf/bacharach/draft ... 26008.html

csstoker · Post by **csstoker** » Tue. Jan. 27, 2009 11:48 am