I have been given a used barometric damper and am trying to decide whether it is worth installing it or whether I should simply go out and get a new one? This is an install of a new stove (my first experience with coal) with a short run of stove-pipe (2 elbows at each end plus 30" of pipe at 45 degree angle in middle) connecting with interior masonry chimney. Chimney is relatively short (couple feet taller than single story roof peak). Oh, stove is a gravity fed hopper cast iron stove (Saey 92). Any and all feedback is welcome.
Thanks!
Used or New Baro?
- Razzler
- Member
- Posts: 434
- Joined: Wed. Dec. 19, 2007 7:56 pm
- Location: Northampton Pa.
- Stoker Coal Boiler: EFM DF520
- Coal Size/Type: rice
I would try the one you have. As long as it's in good shape and you give it a good cleaning first. Your most likely not gonna see it move with a short chimney, maybe when it gets colder out it will flap open.
In my Leisure Line manual it is recommended to replace the baro every 5 years.
Depending on how old the one you have is, it may be worth buying a new one.
I don't know for sure but can only assume (theres that word) that the metal around the pins get a groove worn into them making it harder for the flap to open.
Depending on how old the one you have is, it may be worth buying a new one.
I don't know for sure but can only assume (theres that word) that the metal around the pins get a groove worn into them making it harder for the flap to open.
-
- Member
- Posts: 101
- Joined: Thu. Aug. 28, 2008 4:03 pm
Thanks everyone for your thoughts - looks like I'm going to try out this used one and see what happens with it or if it even moves with my short little chimney. I'm on the list for a manometer so I'll try to get things calibrated correctly from the start.
I really appreciate all the knowledge and information on this forum, I've learned a lot and I just keep reading!
~Rebecca
I really appreciate all the knowledge and information on this forum, I've learned a lot and I just keep reading!
~Rebecca
- Freddy
- Member
- Posts: 7301
- Joined: Fri. Apr. 11, 2008 2:54 pm
- Location: Orrington, Maine
- Stoker Coal Boiler: Axeman Anderson 130 (pea)
- Coal Size/Type: Pea size, Superior, deep mined
A brand new one will be a used one next week. I'd give the used one a try & spend the baro money on a manometer. For about $35 you can pick up a Dwyer #25 on eBay.
hi I am new to this forum but can anyone tell me how you go about adjusting a barometric
damper step by step?Ihave a surdiac 512.been using it as emergency heat when power goes out so I am not to familiar adjusting them.Think I have to spring for a new one.This one is about 20 years old and acts kinda sluggish.BTW I am talking about a manual adjustment,no
gages.
Thanks Edd upper Hudson Valley
damper step by step?Ihave a surdiac 512.been using it as emergency heat when power goes out so I am not to familiar adjusting them.Think I have to spring for a new one.This one is about 20 years old and acts kinda sluggish.BTW I am talking about a manual adjustment,no
gages.
Thanks Edd upper Hudson Valley
While using your new manometer, of you find that you can't get the baro set to work properly and the installation is level and plumb, splurge the $40 or so and buy a new baro. I fooled with an old one I had for hours and hours and it just simply didn't work right, I stuck a new one in and presto! I had it dialed in within a few minutes.