When my stove is shut down for cleaning and I start it back up the feed rate is always over 90. Is there a way to reset this or lower it as I get a full grate of fire when I light it.
Help Please.
Thanks, Stant
Setting the Feed rate on Coal-Trol When Lighting Stove
- pvolcko
- Verified Business Rep.
- Posts: 1063
- Joined: Mon. Jan. 16, 2006 4:26 pm
- Location: Syracuse, NY
- Contact:
When you're cleaning it set the setpoint a bit below room temp, this will keep it from ramping up while it is out of service.
If you have a thermostat with V4 009 or higher version of the firmware there is also a feature to reset the FR logic. Go to the FR screen, press and hold the down button for 15 seconds. The FR will reset to a low value (maybe not 0 depending on where your setpoint is vs room temp).
If you have a thermostat with V4 009 or higher version of the firmware there is also a feature to reset the FR logic. Go to the FR screen, press and hold the down button for 15 seconds. The FR will reset to a low value (maybe not 0 depending on where your setpoint is vs room temp).