Page 67 of 71

Re: COAL BIN Pics

Posted: Mon. Jan. 23, 2017 10:14 pm
by joeq
Will you tell him Tom, or does he even care? ;)

Re: COAL BIN Pics

Posted: Mon. Nov. 06, 2017 9:15 pm
by Kramer1782
IMG_2483.JPG

Open bins.

.JPG | 828.2KB | IMG_2483.JPG
IMG_2482.JPG

With the lid on.

.JPG | 740.4KB | IMG_2482.JPG
IMG_2358.JPG

Dumping that coal.

.JPG | 983.4KB | IMG_2358.JPG
IMG_2484.JPG

Reserve bin.

.JPG | 696.6KB | IMG_2484.JPG
Here are some pics of my temporary coal bins. I took some pallets home from work and put the removable walls on them. I have two side by side that measure 46"x24"x29" each. Then I also have a reserve bin 24"x30"x29" which I will use while inresupply my main bins. The two larger bins should be about 19 cubic feet while the reserve is 12 cubic feet. All together I should be able to hold a little more than a ton. Since they are mounted on pallets I put them in the drive way, back the work dump truck up and just dump the coal right in. Then using the pallet jack, also borrowed from work, I move them into the nice dry garage so I can fill buckets inside this year. Last year I had a pile in the driveway under tarps. I have refilled once already and it's worked out pretty well so far. Also as the bins empty I can remove the walls to gain better access to the lower piles. Plus if I ever need more capacity we always have extra pallets laying around at work.

Re: COAL BIN Pics

Posted: Mon. Nov. 06, 2017 9:37 pm
by Kramer1782
IMG_2408.JPG

Original hopper in bad shape.

.JPG | 1019.1KB | IMG_2408.JPG
IMG_2410.JPG
.JPG | 691.8KB | IMG_2410.JPG
IMG_2412.JPG
.JPG | 747.8KB | IMG_2412.JPG
IMG_2413.JPG
.JPG | 743.8KB | IMG_2413.JPG
IMG_2415.JPG
.JPG | 650KB | IMG_2415.JPG
IMG_2417.JPG
.JPG | 590.1KB | IMG_2417.JPG
IMG_2418.JPG

All done and holding coal.

.JPG | 676.6KB | IMG_2418.JPG
I also just want to take a quick minute and thanks everyone who helped me get up and runningast year when my fire wasn't burning as hot as it should have. The cause was wet coal which this stove has seen a lot of. I bought the house in November 2016 and the previous owner must have hosed the coal down because the stove and hopper were completely rusted out. It has been a long salvage effort where last year I just got up and running. This year I replaced the entire chimney as it just crumbled in my hands and was in pretty bad shape. I also cleaned, overhauled, and polished the stove back to its original glory, or at least as good as I could get it. I also replaced all the door gaskets and cleaned the glass. I didn't make it all the way through cleaning the glass because some that posts suggested it was a lost cause. The biggest project was by far repairing the hopper. Last year it was rotted and rusted out and has holes in the bottoms and sides. I cut up an old metal chair that came with house and patched the holes to make due through the winter. This year I was going to replace with a new one but they are anywhere from 2-3 hundred dollars that I don't have. So after a trip to Lowe's for some thin steel I began cutting and forming a makeshift repair. I basically replaced the whole bottom and sides and riveted the new steal to any good metal on the original hopper I could find. I filled the gaps with high temp rtv to prevent drafts and a coal bin fire. Should last me till next year or two until I can replace it with a new one.

Re: COAL BIN Pics

Posted: Mon. Nov. 06, 2017 10:31 pm
by joeq
Seem to be honing in on it Krammer. Nice to have indoor dry bins, and the ability to move them loaded. I'm a little confused on the hopper. Is it for your Harman, or your coal bin?

Re: COAL BIN Pics

Posted: Tue. Nov. 07, 2017 6:32 am
by Kramer1782
The hopper is for the Harman.

Re: COAL BIN Pics

Posted: Tue. Nov. 07, 2017 4:34 pm
by joeq
Be interesting to see how the tin holds up to the heat. Especially at the bottom, those hoppers get pretty hot.

Re: Coal Bin Pictures and Designs

Posted: Mon. Nov. 20, 2017 11:09 pm
by ScubaSteve
Just finishing up this bin that my father and I are building

Re: Coal Bin Pictures and Designs

Posted: Mon. Nov. 20, 2017 11:14 pm
by joeq
Nice job men. We sure have some talented members.:)

Re: Coal Bin Pictures and Designs

Posted: Tue. Aug. 14, 2018 12:55 am
by Mackman
Holds 7 ton of rice.

Re: Coal Bin Pictures and Designs

Posted: Tue. Aug. 14, 2018 6:21 am
by joeq
Nice job Mack. Looks like you're ready for the season. Curious why the coal wasn't poured into the new bin tho?

Re: Coal Bin Pictures and Designs

Posted: Tue. Aug. 14, 2018 9:37 am
by Mackman
No one delivers coal in my area. So i had to barrow my buddies dump trailer and pick it up.

Re: Coal Bin Pictures and Designs

Posted: Tue. Aug. 14, 2018 5:43 pm
by joeq
Oh...now I see. Maybe you can fab a new ramp for future deliveries? Or dig a pit, to put your bin in. :idea: (always a way, to beat the system.)

Re: Coal Bin Pictures and Designs

Posted: Tue. Aug. 14, 2018 6:46 pm
by Mackman
Well 7 ton should last me around 3 years. So i shouldnt have to fill it much. If i had to do it over. I would have done it differentially. Like putting a auger system in.

Re: Coal Bin Pictures and Designs

Posted: Tue. Aug. 14, 2018 7:04 pm
by joeq
Well, you're further ahead than me Mack. At least you have a bin. Enjoy it. :yes:
(P.S. Just curious about your screen name. Anything to do with the truck?)
Image

Re: Coal Bin Pictures and Designs

Posted: Tue. Aug. 14, 2018 8:38 pm
by Mackman
Own 4 of them. Plus 2 western stars!! Can't beat a bulldog!!