Barometric Damper Placement?

This forum is for common products and questions such as chimney installations, CO detectors, coal bin designs and a variety of other general topics that do not fit into the other forums.
Post Reply
94Bison
Member
Posts: 26
Joined: Thu. Dec. 20, 2012 5:31 am
Stove/Furnace Make: Alaska
Stove/Furnace Model: Channing III
Location: Allegany, NY

Post Mon. Dec. 24, 2012 7:57 pm

My stove has a rear vent. I have a 1 ft. pipe off the back hooked to a 90 then a 2 ft. section up hooked to the damper into another 2 foot section to a cut section about 1.5 foot to another 90 hooked to the powervent. My question....should I move the damper down to hook to the elbow then put the 2 ft. section above or is it ok the way it is? It seems I have read the recommendation is to hook the damper right into the 90 at the bottom. Will my current set up cause any problems? Thanks in advance for any insight!


User avatar
McGiever
Member
Posts: 6009
Joined: Sun. May. 02, 2010 11:26 pm
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Coal Size/Type: PEA / ANTHRACITE
Other Heating: Ground Source Heat Pump
Stove/Furnace Make: Hydro Heat /Mega Tek
Location: Junction of PA-OH-WV

Post Mon. Dec. 24, 2012 8:04 pm

The way you have it is best. :)
SLOW AND STEADY WINS THE RACE

Post Reply

Return to “Coal Bins, Chimneys, CO Detectors & Thermostats”