Installing Single Wall Chimney for Coal Stove?

User avatar
europachris
Member
Posts: 1003
Joined: Sat. Dec. 09, 2006 5:54 pm
Stove/Furnace Make: EFM 350/Iron Fireman
Stove/Furnace Model: Custom bituminous burner
Location: N. Central Illinois

Post By: europachris » Tue. Nov. 06, 2007 11:09 am

Here's how I sealed my grate with furnace cement at the rear edge as well as the sides up to the first row of holes. I have absolutely no issues with smoke through the hopper or burnback whatsoever.
DSC03440.JPG
Sealed grate with furnace cement
Chris

Jose
New Member
Posts: 1
Joined: Sat. Jan. 27, 2018 8:33 pm
Hand Fed Coal Stove: Harman mark 1

Post By: Jose » Tue. Jan. 30, 2018 8:10 pm

Do you guys think running 2 90 degree elbows and going directly into a masonry chimney is ok for drafting. I have a harman mark 1. Also there will be a slope from thr second elbow going slightly upwards to the chimney

User avatar
Lightning
Member
Posts: 10024
Joined: Wed. Nov. 16, 2011 9:51 am
Hand Fed Coal Furnace: Overmodified/Bored out Clayton 1537
Coal Size/Type: Nut/Stove Size Mix
Location: Olean, NY

Post By: Lightning » Tue. Jan. 30, 2018 10:25 pm

Is this an interior or exterior chimney? and how tall is it?

Visit DS Stoves

User avatar
titleist1
Member
Posts: 4721
Joined: Wed. Nov. 14, 2007 4:06 pm
Hot Air Coal Stoker Stove: Harman Mag Stoker - one in basement, one in workshop
Hand Fed Coal Stove: Harman Mark III on standby for long power outages
Coal Size/Type: Rice/Anthracite; Nut/Anthracite
Location: Cecil County, MD

Post By: titleist1 » Wed. Jan. 31, 2018 7:34 am

Jose wrote:
Tue. Jan. 30, 2018 8:10 pm
Do you guys think running 2 90 degree elbows and going directly into a masonry chimney is ok for drafting. I have a harman mark 1. Also there will be a slope from thr second elbow going slightly upwards to the chimney
Welcome to the forum Jose....Is it just the two 90's from the stove to the chimney or is there straight pipe also? If there, how long are the straight pipe sections?

User avatar
freetown fred
Member
Posts: 23608
Joined: Thu. Dec. 31, 2009 12:33 pm
Hand Fed Coal Stove: HITZER 50-93
Coal Size/Type: BLASCHAK Nut
Location: Freetown,NY 13803

Post By: freetown fred » Wed. Jan. 31, 2018 7:54 am

Not really familiar with the stove but if the outlet is in the back a "T" would work best & then your 90* going in to the chimney. 90's tend to accumulate fly ash. With a "T" you could clean out if necessary much easier. Or what T posted with his pix, those elbows are adjustable.

Post Reply

Return to “Coal Bins, Chimneys, CO Detectors & Thermostats”