Page 1 of 1
Alaska stove heat duct
Posted: Sat. Oct. 01, 2022 2:26 pm
by CoalKracker
Hey everybody. I have an Alaska channing 3 that I would like to put a heat duct from to shoot some warm air up into the room directly above. Does anyone have a Channing with the duct collar on the lid that would be willing to take a measurement? I'm just looking for a measurement from either the front or the back of the lid, doesn't matter.
Re: Alaska stove heat duct
Posted: Mon. Oct. 03, 2022 5:23 pm
by CoalKracker
Nobody has one with a duct collar that they can measure the location on the lid? I'm trying to get it close to where Alaska puts them in the factory.
Re: Alaska stove heat duct
Posted: Wed. Nov. 16, 2022 12:48 pm
by Chromel
I would like to add a 6 inch duct off of my Channing II as well.
After looking on Alaska’s site the duct ring looks to be centered on the plate.
Did you end up installing a duct? Where did you get the ring and how did you cut the hole?
Re: Alaska stove heat duct
Posted: Tue. Nov. 22, 2022 9:10 pm
by CoalKracker
No I haven't. I decided to cut in a few registers instead.