Alaska stove heat duct
-
CoalKracker
- Member
- Posts: 115
- Joined: Sat. Oct. 03, 2015 10:56 am
- Location: Northeast Pa
- Hot Air Coal Stoker Stove: Alaska Channing 3
- Hand Fed Coal Stove: Warm Morning 460
- Baseburners & Antiques: Pittston Stove Co. Magnet No.2
- Coal Size/Type: Anthracite rice (reading coal co)
Hey everybody. I have an Alaska channing 3 that I would like to put a heat duct from to shoot some warm air up into the room directly above. Does anyone have a Channing with the duct collar on the lid that would be willing to take a measurement? I'm just looking for a measurement from either the front or the back of the lid, doesn't matter.
-
CoalKracker
- Member
- Posts: 115
- Joined: Sat. Oct. 03, 2015 10:56 am
- Location: Northeast Pa
- Hot Air Coal Stoker Stove: Alaska Channing 3
- Hand Fed Coal Stove: Warm Morning 460
- Baseburners & Antiques: Pittston Stove Co. Magnet No.2
- Coal Size/Type: Anthracite rice (reading coal co)
Nobody has one with a duct collar that they can measure the location on the lid? I'm trying to get it close to where Alaska puts them in the factory.
-
Chromel
- New Member
- Posts: 3
- Joined: Thu. Apr. 21, 2022 9:57 am
- Stoker Coal Boiler: Alaska Channing
- Hand Fed Coal Stove: Chubby
- Other Heating: Oil
I would like to add a 6 inch duct off of my Channing II as well.
After looking on Alaska’s site the duct ring looks to be centered on the plate.
Did you end up installing a duct? Where did you get the ring and how did you cut the hole?
After looking on Alaska’s site the duct ring looks to be centered on the plate.
Did you end up installing a duct? Where did you get the ring and how did you cut the hole?
-
CoalKracker
- Member
- Posts: 115
- Joined: Sat. Oct. 03, 2015 10:56 am
- Location: Northeast Pa
- Hot Air Coal Stoker Stove: Alaska Channing 3
- Hand Fed Coal Stove: Warm Morning 460
- Baseburners & Antiques: Pittston Stove Co. Magnet No.2
- Coal Size/Type: Anthracite rice (reading coal co)
No I haven't. I decided to cut in a few registers instead.