Not sure if I should make a separate thread or just continue..
Modified the air channel under the grate.. some cutting and TIG later.
I am going to make the carpet plate from SS sheet..
Johan
Vertiflow or carpet stoker ??
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
Looking good!!!
Maybe have a look here:
https://www.surpluscenter.com/Electrical/Blowers- ... l-Blowers/
Maybe have a look here:
https://www.surpluscenter.com/Electrical/Blowers- ... l-Blowers/
-
- Member
- Posts: 1137
- Joined: Fri. Feb. 12, 2016 2:36 pm
- Hand Fed Coal Boiler: Harman SF360
- Hand Fed Coal Stove: T.O.M (Warm Morning converted to baseburner by Steve) Round Oak 1917 Door model O-3, Warm Morning 400, Warm Morning 524, Warm Morning 414,Florence No.77, Warm Morning 523-b
- Hand Fed Coal Furnace: Clayton 7.1/DS Machine basement stove/ Harman SF1500
- Baseburners & Antiques: Renown Parlor stove 87B
- Coal Size/Type: Bituminous/anthracite
- Other Heating: Harman Accentra, enviro omega, Vermont Ironworks Elm stove, Quadrafire Mt Vernon, Logwood stove, Sotz barrel stove,
How did you determine the angle to set the grates at?
I kept the angles the same as in the original Alaska stoker..essential I just extended the the sheet metal in front of the grate to accommodate the double back wall and the additional ceramic tiles the Harman uses..
Hope to have some coal left to do a test run after I get the combustion fan worked out.
Johan
Hope to have some coal left to do a test run after I get the combustion fan worked out.
Johan