Hitter 608 no power

Post Reply
 
Soccer918843
Member
Posts: 114
Joined: Thu. Aug. 27, 2020 11:44 am

Post by Soccer918843 » Fri. Dec. 18, 2020 11:30 pm

I came home from work to a cold house my 608 has no power the power vent is running fine but the blowers on the stove and the lights are not on what could this be?

 
User avatar
WNY
Member
Posts: 6307
Joined: Mon. Nov. 14, 2005 8:40 am
Location: Cuba, NY
Hot Air Coal Stoker Stove: Keystoker 90K, Leisure Line Hyfire I
Coal Size/Type: Rice
Contact:

Post by WNY » Sat. Dec. 19, 2020 6:50 am

check all connections, unplug and power back up.
if it has a flume switch, it might have tripped, needs reset.

 
Soccer918843
Member
Posts: 114
Joined: Thu. Aug. 27, 2020 11:44 am

Post by Soccer918843 » Sat. Dec. 19, 2020 9:57 am

Looks to be either it’s the vacuum line or vacuum switch


 
User avatar
McGiever
Member
Posts: 10130
Joined: Sun. May. 02, 2010 11:26 pm
Location: Junction of PA-OH-WV
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hand Fed Coal Boiler: BUCKET A DAY water heater
Hand Fed Coal Stove: Warm Morning 414A
Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
Other Heating: Ground Source Heat Pump and some Solar

Post by McGiever » Sat. Dec. 19, 2020 12:20 pm

Soccer918843 wrote:
Sat. Dec. 19, 2020 9:57 am
Looks to be either it’s the vacuum line or vacuum switch
So you understand...that is a "safety" doing it's job to save your life...understand the "cause" of safety engaement and correct that "cause". Clearing the tube is not clearing the cause...you have some work to do to return stove back to run again as it did when stove was new.

 
Soccer918843
Member
Posts: 114
Joined: Thu. Aug. 27, 2020 11:44 am

Post by Soccer918843 » Sat. Dec. 19, 2020 12:32 pm

The vacuum switch is faulty I am ordering a new vacuum switch and part

Post Reply

Return to “Stoker Coal Furnaces & Stoves Using Anthracite (Hot Air)”