Hi,
I bought a 4 year old Pioneer off craigslist and have had it running since Sunday. So far so good but the combustion blower sounds rough and I have the max feed rate turned pretty low to keep unburnt coal from falling off. From what I saw on the pail here, the quiet century was not a very good motor for this stove.
Just wanted to confirm that i could replace the whole unit with the Dayton 1TDN5 with no issues.
Thanks,
Travis
Leisure Line Pioneer Combustion Replacement
- WNY
- Member
- Posts: 6307
- Joined: Mon. Nov. 14, 2005 8:40 am
- Location: Cuba, NY
- Hot Air Coal Stoker Stove: Keystoker 90K, Leisure Line Hyfire I
- Coal Size/Type: Rice
- Contact:
Many motor have oil holes on them, sometimes on the bottom that normally need oiled regularly that normally helps them out and prolongs the life.
If the replacement motor is the same CFM, RPM, etc... it should work.
If the replacement motor is the same CFM, RPM, etc... it should work.
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
If this can fit you will love how smooth, quite and cool it runs with ball bearings, lubed for life too.
Not a crapo Shaded Pole, this is a high quality Permanent Split Capacitor Motor
Dayton-1TDN6-Permanent-Capacitor-Specialty
http://www.electricmotorwarehouse.com/content/PDF ... _specs.pdf
Not a crapo Shaded Pole, this is a high quality Permanent Split Capacitor Motor
Dayton-1TDN6-Permanent-Capacitor-Specialty
http://www.electricmotorwarehouse.com/content/PDF ... _specs.pdf
- coaledsweat
- Site Moderator
- Posts: 13766
- Joined: Fri. Oct. 27, 2006 2:05 pm
- Location: Guilford, Connecticut
- Stoker Coal Boiler: Axeman Anderson 260M
- Coal Size/Type: Pea
You can puta few drops on the shaft near the bushing if so equipped. It will find its way to the bushing. Make sure the cups of the fan blades are clean, use an old toothbrush. A squirrel cage fan can lose half its airflow if the cups fill up with dust and hair.