Pellet exhaust vent pipe for coal stove
-
- Member
- Posts: 50
- Joined: Thu. Dec. 14, 2017 12:58 pm
- Other Heating: pellet
Has anyone used stainless 4" pellet pipe for outside component of the exhaust pipe on a direct vent stove. I see Harman was using pellet pipe on the outside section of the DVC-500 venting....but no one else. Has anyone with a Keystoker used this. I am sure the factory won't give the ok for liability reasons, but real world input often trumps the factory info. As usual, thanks for the input
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
Pellet stove vent pipe quality or grade of the SS may be lower for a lesser acidity level of a wood fuel , but this doesn't mean it would not work. Attention to after season cleaning could overcome some of this possible effect.
Don't be skered.
Don't be skered.