Hey Folks
Some of you had commented on my Old Mill Stoker in the past, and I see a few folks have them out there. I got it cranking away, had to replace the Convection Fan (like the other forum member, maybe I should have checked the on/off switch, it didn't have a Dimmer Switch) no problem, just rigged a dual Squirrel Cage,- NOW the Stoker Motor and Combustion blower have quit. Am I right to assume if that Stoker Motor fails, it will not send power to the Combustion Blower?? It is quite the setup with the Paragon PCT timer (which is still getting Power, and cycling correctly on and off) and an old school Thermostat.
I will remove the motor and test it Independent of everything, as well as the Combustion Blower...Any idea where I might find a compatible Stoker Motor??? I have included a few pics..thanks,
Dave
Old Mill Stoker Motor?
- licavoli34
- Member
- Posts: 41
- Joined: Sun. Nov. 30, 2014 10:23 pm
- Hot Air Coal Stoker Furnace: Hitzer 608
- Hot Air Coal Stoker Stove: Old Mill Stoker
- Baseburners & Antiques: Guerney Foundry, Cleveland Stove Co-op (2), Beckwith Round Oak,
- Coal Size/Type: Rice
- Other Heating: Red Efel Kamina (Wood), Nat Gas (Rudd 80%)
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
cannot know your RPM, but this looks alright.
https://www.ebay.com/itm/Alaska-Coal-Stove-Air-co ... SwXeJYGeEv
https://www.ebay.com/itm/Alaska-Coal-Stove-Air-co ... SwXeJYGeEv
- licavoli34
- Member
- Posts: 41
- Joined: Sun. Nov. 30, 2014 10:23 pm
- Hot Air Coal Stoker Furnace: Hitzer 608
- Hot Air Coal Stoker Stove: Old Mill Stoker
- Baseburners & Antiques: Guerney Foundry, Cleveland Stove Co-op (2), Beckwith Round Oak,
- Coal Size/Type: Rice
- Other Heating: Red Efel Kamina (Wood), Nat Gas (Rudd 80%)
Thanks for the reply, It says that is a Combustion Air Motor? Mine actually has a small squirrel cage blower for Combustion Air, although I see they have a Stoker Motor for a Paddle assembly also? The Shaft of my Motor is offset from the actual Motor Assembly. Couldn't get a good picture until I remove it...