Hey all,
I've had my Keystoker Koker Lite for 1 year now. I've been noticing some hesitation with the room blower going to turn on. It sounds like the blower tries to turn on and stutters, then re-tries again. When I push the button for continuous, the blower runs. If I fiddle with the fan limit switch dial, the furnace seems to run normally for awhile, but then it goes back to the stuttering symptoms. Tried changing the filters on the blower to no avail. Any help is appreciated!
-John
Room Blower Hesitation
-
- New Member
- Posts: 1
- Joined: Fri. Feb. 16, 2018 6:33 pm
- Hot Air Coal Stoker Furnace: Koker Lite
- Coal Size/Type: Anthracite Rice
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
It is most likely the fan switch electrical contacts doing that.
Since you can run it w/ over ride button the contacts may be dirty.
Only other thing is maybe your set points are too close together, but I doubt that it is possible to get them so close together to do what you describe.
Since you can run it w/ over ride button the contacts may be dirty.
Only other thing is maybe your set points are too close together, but I doubt that it is possible to get them so close together to do what you describe.