Well actually it was a small chisel and hammer and a lesson learned..Pacowy wrote: Lastly, I suggest minimizing use of a hammer to remove rust from cast.
Mike
Rob, Yes, a 1/4 drill bit fits in the holes tight, at least the ones with out the extra rust.
According to the service tags, the upper auger and gooseneck bushing were replaced 4/29/09, no mention of the feed pipe. Also there is no mention that I can tell from 10/03 earliest date on the tags, that the grates or gaskets were serviced/replace. I'll have to post the tags kind of interesting history of the 150.