Page 2 of 2
Re: Summerizing My Coal Stoker, Looking for Tips?
Posted: Mon. Mar. 17, 2008 7:02 am
by sauerzbr
Thanks everyone! Some great tips!
I am partial to CRC products as I've been using them for years on my marine engines. Great stuff and really does the job!
Re: Summerizing My Coal Stoker, Looking for Tips?
Posted: Fri. Apr. 18, 2008 9:32 am
by BugsyR
Baking Soda and Water mix....what's the ratio everyone uses? How many parts BSoda to water? Does it matter?
Re: Summerizing My Coal Stoker, Looking for Tips?
Posted: Fri. Apr. 18, 2008 9:50 am
by LsFarm
A box of soda to a two gallon bucket of water is what I use.
Greg L
Re: Summerizing My Coal Stoker, Looking for Tips?
Posted: Fri. Apr. 18, 2008 10:00 am
by BugsyR
LsFarm wrote:A box of soda to a two gallon bucket of water is what I use.
Greg L
Thanks Greg.
Re: Summerizing My Coal Stoker, Looking for Tips?
Posted: Wed. Jul. 30, 2008 9:14 am
by szembek
I cleaned out my keystoker A120 last weekend, and found quite a bit of surface rust on the heat exchanger, and in the firebox. I think my biggest mistake was not disconnecting the stove pipe and cleaning the furnace immediately after the heating season. I got it cleaned out very well, and left the stove pipe disconnected (plugged the thimble) and am running my dehumidifier 24/7 with the stove doors and flue open. The grate and pusher mechanism look perfect, it's really just the heat exchanger and firebox walls that got surface rusty. I got as much ash out as I could, I think trying to clean around in the heat exchanger area with baking soda and water would be a complete and utter mess though. It's very hard to get in there. I have a can of the CRC 350, would it do any good to spray it on the already rusty areas? Should I scrape the flaking metal off of there first?