Older Harman St8 Control Settings

Post Reply
 
User avatar
munson
New Member
Posts: 2
Joined: Fri. Nov. 23, 2012 11:12 am

Post by munson » Fri. Nov. 23, 2012 11:25 am

hi, i'm new to the forum and i'm needing a little help..i was given an older Harman st8 for free,i just had to clean it up a little..i'm ready to fire it up and I have no manual with this stoker,,my controller has three sets of rocker type switches inside marked....p,d, and off..any help with identifying and starting point settings would be greatly appreciated..thanks

...there are no pots to turn for settings and there is only a main power on/off switch on the control box...

 
User avatar
blrman07
Member
Posts: 2383
Joined: Mon. Sep. 27, 2010 3:39 pm
Location: Tupelo Mississippi

Post by blrman07 » Fri. Nov. 23, 2012 11:47 am

Contact Harman directly

Harman Stove Co
Address: 352 Mountain House Rd
Halifax, PA,
17032-9733

Phone: 717-362-9080
Fax: 717-362-4251
Website: http://www.harmanstoves.com

 
User avatar
RAYJAY
Member
Posts: 433
Joined: Sun. Nov. 09, 2008 7:06 am
Location: UNION DALE PA
Stoker Coal Boiler: VAN WERT - 600 VA HOT WATER
Hot Air Coal Stoker Stove: HARMAN- MAGUM STOKER
Coal Size/Type: BUCKWHEAT ON BOTH
Other Heating: NG BOILER

Post by RAYJAY » Fri. Nov. 23, 2012 1:45 pm

you can call this dealer ask for dave or his wife he been selling Harman since day one

Fisher Stoves Showroom

(570) 836-3343

Rr 6

Factoryville, PA 18419


 
User avatar
RAYJAY
Member
Posts: 433
Joined: Sun. Nov. 09, 2008 7:06 am
Location: UNION DALE PA
Stoker Coal Boiler: VAN WERT - 600 VA HOT WATER
Hot Air Coal Stoker Stove: HARMAN- MAGUM STOKER
Coal Size/Type: BUCKWHEAT ON BOTH
Other Heating: NG BOILER

Post by RAYJAY » Fri. Nov. 23, 2012 1:48 pm

also this thread

Harmon ST8-VF8

 
User avatar
munson
New Member
Posts: 2
Joined: Fri. Nov. 23, 2012 11:12 am

Post by munson » Fri. Nov. 23, 2012 5:55 pm

thanks for all the replies,,fisher stoves doesn't have any info on settings as the stove is approx 25-27 yrs. old,,did learn that the stove model is magnafire,not magnum,,harman is on vacation for the weekend,so no info from them yet,the st8 link was very helpful,learned alot about cleaning issues...i have a feeling Harman is gonna want to push a newer version controller at a cost of over $400...my controller is fine I just have no idea about identifying switch posistions or starting settings to use,,i guess I could sit all the motors on a workbench and make adjustments one at a time and record changes,,,uuggghhhh....any other ideas????thanks to all who replied....munson

Post Reply

Return to “Stoker Coal Furnaces & Stoves Using Anthracite (Hot Air)”