Factory Settings With Jacket Installed on Hyfire II
Posted: Wed. Nov. 07, 2007 1:42 pm
Have been running my Hyfire for three seasons now, this summer installed the jacket. I also installed two eight inch inline fans and a six inch inline fan, and removed the two factory installed blowers. The six inch inline fan is hooked up independently. Everything is up and running, like this setup vice sans jacket.
My question. With one burner going at FR99, the fan inlet temperatures are 115 to 125 degrees, they are rated at 260 degrees so no problem so far. I would like to closely monitor the temp when I have both burners going, so as not to exceed the max temp of the inline fans. My settings on the Coal Trol are 6/40, can I lower the 40 to a given setting and periodically raise it while monitoring the fan temperature. If so, what setting should I start at. I think this adjustment would be easier and more precise than the feeder knobs on the stove itself.
Thanks
My question. With one burner going at FR99, the fan inlet temperatures are 115 to 125 degrees, they are rated at 260 degrees so no problem so far. I would like to closely monitor the temp when I have both burners going, so as not to exceed the max temp of the inline fans. My settings on the Coal Trol are 6/40, can I lower the 40 to a given setting and periodically raise it while monitoring the fan temperature. If so, what setting should I start at. I think this adjustment would be easier and more precise than the feeder knobs on the stove itself.
Thanks