Page 3 of 3

Re: My Econo Is up and Running!!

Posted: Sun. Nov. 16, 2008 9:36 pm
by Cowboy
As I said I am a newbie with these types of stoves. Yes it is a power vent, the motor is mounted outside on this power vent. And yes the damper has been checked by the tech three different times and it is running perfect. No I don't run the stove open, only once in a great while do I up the temp on the thermostat a couple of degrees. I tried a bag of blaschak and noticed no real difference. One difference I noticed though is that I did not get the cluster of ash in the pan. Part of the trouble is the fan does not run at full speed. When I get a hot fire the fan will run on high for a short period of time and slows down. At that point I put the fan on manual via the thermostat until the fire dies down some. Then I will switch it back over auto.

Re: My Econo Is up and Running!!

Posted: Sun. Nov. 16, 2008 9:42 pm
by Cowboy
here are the setting on my therm.
deg F
min 4 feed
max 25 feed
cft 0 convection fan setting
ign n no ignition
n 72 night temp setting
d 72 day temp setting

Re: My Econo Is up and Running!!

Posted: Mon. Nov. 17, 2008 9:24 am
by Rick 386
Cowboy,

Which version of the Coal Trol do you have ??

Have you read through the new version 3 thread that they have posted ?? Here : Coal-Trol V3 Firmware Features

They do mention the fan starting and stopping issue.

Hang in there, we'll get this thing straightened out.

-----------------------------------

Rick

Re: My Econo Is up and Running!!

Posted: Tue. Nov. 18, 2008 8:35 am
by Cowboy
I have the TS2 con trol

Re: My Econo Is up and Running!!

Posted: Tue. Nov. 18, 2008 6:04 pm
by hell fire
think your max of 25 may be to low to be getting much heat out of stove I have my min@5 and max@52.