Oiled Coal at Breaker
I tried the cheapest veg oil I could find at Sams club. Stored for a short period in the summer it attracted many mice. Not good. For personal use some petro based oil may work , but for commercial I would worry about environmental issues, wouldnt bulk coal stored outside with petroleum leaching into the ground be a hazard? In my experience water works well, just don't use too much.
commercial's not a problem, you spray it before you load it, you don't spray it and leave it sitting around. for home use, as long as it's covered it's not going to leach anything and more importantly, it won't be sprayed with so much oil that it should leach anything substantial anyway. I like a 0w20 motor oil. or a used motor oil, but it's a little thicker; probably about 1/2 gallon/ton, mabey less.
-
- Member
- Posts: 533
- Joined: Fri. Jan. 25, 2008 11:55 pm
- Hand Fed Coal Stove: Harman SF250 & Mark III backup
- Other Heating: Oil Hot Water
I'm using oiled coal for the second year and won't go back to wet or dryed coal. A quick simple solution is to buy a small bottle or two of mineral oil at Walmart, you'll find it around the pharmacy isle. Dump some (1/4 to 1/2 bottle) into a garden water can using HOT water. This will break up the oil and spread it around the pile.
For larger quantities look up STEoil.com they will sell larger quantities of food grade oil.
Best of luck!
For larger quantities look up STEoil.com they will sell larger quantities of food grade oil.
Best of luck!
Dry coal was a mess.
Wet coal is OK and definitely better than dry.
Professionally oiled (and wetted) was the best.
My own attempts at used motor oil were not inspiring. It stunk terribly and was smokey. It also left soot all over the inside of the boiler. Yes, I probably added too much, but I won't be trying that again any time soon.
A bucket of damp-rid inside the boiler a dry basement with plastic covering the breech, an empty+sealed hopper. Dry. No problems.
Wet coal is OK and definitely better than dry.
Professionally oiled (and wetted) was the best.
My own attempts at used motor oil were not inspiring. It stunk terribly and was smokey. It also left soot all over the inside of the boiler. Yes, I probably added too much, but I won't be trying that again any time soon.
A bucket of damp-rid inside the boiler a dry basement with plastic covering the breech, an empty+sealed hopper. Dry. No problems.
- EarthWindandFire
- Member
- Posts: 1594
- Joined: Sat. Dec. 18, 2010 12:02 pm
- Location: Connecticut
- Hot Air Coal Stoker Furnace: Leisure Line Lil' Heater.
- Other Heating: Oil Furnace and Kerosene Heaters.
http://www.advancedlubes.com/product/advantage-co ... -spray-oil
Without looking on the internet all day, I was able to find this link for a company called; Advanced Lubrication Specialties based in Bensalem PA.
Mark
Without looking on the internet all day, I was able to find this link for a company called; Advanced Lubrication Specialties based in Bensalem PA.
Mark