Hello everyone, I'm new to this forum and from what I read so far there is a lot of smart people on here and hopefully someone can help me.
I have a keystoker stoker 90 I believe, with a coal-trol model TS2. The combustion blower motor went out, so I bought a new motor and went to install it. I removed the old one and installed the new one and I guess I mis matched a few wires. Going to the feed, because I lit the stove and went along with my day, and as I walked by it the stove was out. I didn't know what was going on because everything worked properly besides the feed. So I re-lit the stove and hit the feed10 on the coal-trol to test the feed, and nothing happened. If anyone has a wiring diagram or could explain to me what wires go where that would be great. I really appreciate the help!
Keystoker Coal-Trol Wiring Diagram
- 2001Sierra
- Member
- Posts: 2211
- Joined: Wed. May. 20, 2009 8:09 am
- Location: Wynantskill NY, 10 miles from Albany
- Hot Air Coal Stoker Stove: Keystoker 90 Chimney vent
- Coal Size/Type: Rice
- Other Heating: Buderus Oil Boiler 3115-34
The feed motor goes to the flume switch (electrical box on stove back) then wired to stoker outlet on Coal-trol controller box. Mine is installed on a chimney vent model.
- WNY
- Member
- Posts: 6307
- Joined: Mon. Nov. 14, 2005 8:40 am
- Location: Cuba, NY
- Hot Air Coal Stoker Stove: Keystoker 90K, Leisure Line Hyfire I
- Coal Size/Type: Rice
- Contact:
hook up diagrams are on the coaltrol site.
http://www.automationcorrect.com/coaltrolstandardplus.htm
Wiring diagrams are on the Keystoker site.
http://keystoker.com/manuals/2012/Instruction%20Manual%20-%2090K-105K%20Direct%20Vent%20Thermostat.pdf
http://www.automationcorrect.com/coaltrolstandardplus.htm
Wiring diagrams are on the Keystoker site.
http://keystoker.com/manuals/2012/Instruction%20Manual%20-%2090K-105K%20Direct%20Vent%20Thermostat.pdf