Coalpail.com Forum

I like it! Been thinking about a setup here, gives me some ideas!

2300 lb in 11 minutes off my trailer, shot for 400 rpm, works great for me.total setup was a lil less the 400$. if you can see the way I mounted motor with allthread its the way to go.
Ps my coal bin has a slanted floor so I don't shovel in there either, just open my slider door coal runs right in my homemade bucket.

Happy Heating without the shovel, Ha HA

Stan

Stan

Good hustle man, I want one. We need a wide angle shot to see the whole setup as well as some specifics on the equipment and where you got it. You trying to tease us or what? Give up the goods already

Waldo

Fry's
907 Bush Hollow Rd
Pennsdale, PA 17756
Phone: (570) 546-3968
Tractor supply sells one also, I got a 1 hp, only need 1/2 with reduction.

Fax: (570) 546-5940

Ohhhhh yes indeeedy Stan Da Man! hahaha. how do we build one with an old reclaimed motor & $42.00 (thats would make a great thread!)...."Smitty!"

some old auger screws around but I could not find one, pvc pipe, couple of brackets, the auger screw is hard to find.
I think the auger assembly was arounf 220$ 160 for motor and I changed pulleya and belt.

Good luck everyone

Stan

Here is *StanT's* other post...Auger Links