Discussion for Warm Temperature Low Heat Stove Tending
- ShawnLiNy
- Member
- Posts: 627
- Joined: Fri. Nov. 30, 2018 12:28 am
- Hand Fed Coal Stove: Waterford
- Coal Size/Type: Nut
That makes sense ( I’m running 4 probes so 2 weeks to drain ) I had a really early single probe that I bought on clearance for 30- or so back in 2010 ( but 408* was the max temp so I positioned the probe halfway down the side than add 100* ) if you wanted to read 600* degrees remotely 10 years ago it would’ve cost close to 1000- just a single thermocouple was 100- or so , than you need low voltage and basically program your own unit . And buying anything back then you would need to wait 2-3 weeks for delivery
- ShawnLiNy
- Member
- Posts: 627
- Joined: Fri. Nov. 30, 2018 12:28 am
- Hand Fed Coal Stove: Waterford
- Coal Size/Type: Nut
ShawnLiNy wrote: ↑Sat. Feb. 18, 2023 9:17 amThat makes sense ( I’m running 4 probes so 2 weeks to drain ) I had a really early single probe that I bought on clearance for 30- or so back in 2010 ( but 408* was the max temp so I positioned the probe halfway down the side than add 100* ) if you wanted to read 600* degrees remotely 10 years ago it would’ve cost close to 1000- just a single thermocouple was 100- or so , than you need low voltage and basically program your own plc unit And buying anything back then you would need to wait 2-3 weeks for delivery
- davidmcbeth3
- Member
- Posts: 8505
- Joined: Sun. Jun. 14, 2009 2:31 pm
- Coal Size/Type: nut/pea/anthra
https://en.wikipedia.org/wiki/Galileo_thermometer
I only use Galilean thermometers ... no power needed
I only use Galilean thermometers ... no power needed