Harman Mark I New Owner

 
User avatar
ASea
Member
Posts: 1156
Joined: Thu. Nov. 27, 2014 8:55 pm
Location: Athol Massachusetts
Hot Air Coal Stoker Stove: Alaska Kast Console II
Hand Fed Coal Stove: Coal Chubby
Baseburners & Antiques: Glenwood Modern Oak 114, Glenwood 30 "Estate" Warm Morning 120
Coal Size/Type: Sherman Anthracite Nut/Stove from C&T Coal
Other Heating: Peerless Boiler with Cast Iron Baseboards

Post by ASea » Sat. Jan. 22, 2022 11:24 am

Glad you got everything worked out. What sort of burn times are you getting with the MKI?

 
User avatar
exwoodburner
Member
Posts: 189
Joined: Thu. Aug. 12, 2021 10:46 am
Location: Southwest Pennsylvania
Hand Fed Coal Stove: Harman Mark I
Coal Size/Type: Reading Chestnut
Other Heating: Natural Gas Forced Air Furnace

Post by exwoodburner » Sat. Jan. 22, 2022 12:00 pm

waytomany?s wrote:
Sat. Jan. 22, 2022 7:40 am
Did you find any clinkers or just ash?
Just fine ash. I have not really had any clinkers with this load of Redding nut coal. Every once in a while when I shake I'll get some resistance but nothing that jams the grates totally.
ASea wrote:
Sat. Jan. 22, 2022 11:24 am
What sort of burn times are you getting with the MKI?
My normal routine is 12 hours at 400-450 degrees on the top of the side. Tending the stove at 5am and 5pm (before and after work). But I have got 15 hours at those temps on occasions where I was not home at a normal time. The longest I have got out of the stove is 21 hours but it was running very easily on one of the warm days in December.

 
User avatar
McGiever
Member
Posts: 10130
Joined: Sun. May. 02, 2010 11:26 pm
Location: Junction of PA-OH-WV
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hand Fed Coal Boiler: BUCKET A DAY water heater
Hand Fed Coal Stove: Warm Morning 414A
Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
Other Heating: Ground Source Heat Pump and some Solar

Post by McGiever » Sat. Jan. 22, 2022 12:20 pm

@ *exwoodburner*

Good lesson learned :clap:

What is price for bag of Reading coal nut size at Chris’s?

 
User avatar
exwoodburner
Member
Posts: 189
Joined: Thu. Aug. 12, 2021 10:46 am
Location: Southwest Pennsylvania
Hand Fed Coal Stove: Harman Mark I
Coal Size/Type: Reading Chestnut
Other Heating: Natural Gas Forced Air Furnace

Post by exwoodburner » Sat. Jan. 22, 2022 1:39 pm

McGiever wrote:
Sat. Jan. 22, 2022 12:20 pm

What is price for bag of Reading coal nut size at Chris’s?
I'm not sure on bagged. I purchased bulk coal back in late October and it was $248/ton if I remember correctly. I got a shade over a ton in my dump trailer. I have a tarp over it to keep it dry and I just shovel the coal right out of it into a wheel barrow. So much easier than messing with wood.


 
User avatar
McGiever
Member
Posts: 10130
Joined: Sun. May. 02, 2010 11:26 pm
Location: Junction of PA-OH-WV
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hand Fed Coal Boiler: BUCKET A DAY water heater
Hand Fed Coal Stove: Warm Morning 414A
Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
Other Heating: Ground Source Heat Pump and some Solar

Post by McGiever » Sat. Jan. 22, 2022 9:32 pm

I can call or drive over there one day and see how much it all is.

Thanks

 
User avatar
exwoodburner
Member
Posts: 189
Joined: Thu. Aug. 12, 2021 10:46 am
Location: Southwest Pennsylvania
Hand Fed Coal Stove: Harman Mark I
Coal Size/Type: Reading Chestnut
Other Heating: Natural Gas Forced Air Furnace

Post by exwoodburner » Mon. Dec. 26, 2022 9:13 am

Since its been so cold out and technically Winter now I figured I would check in here and revive my old thread on my Harman Mk I. I lit up on Thursday night when I got home from work. The little Mark I has carried my house through the extreme cold temperatures the past few days. 85 degrees in the basement and 70 degrees upstairs. I think we were around -7 degrees and 30mph winds Friday night and all day Saturday. Really brutal out. I really ran it hard the last couple of days going through about 25-30 pounds of Reading nut coal per day. I have about half a ton left over from last year. Haven't bought any yet as I hear it has gone through the roof. Hopefully what I have will get me somewhere into February and I will just wait and see what the temps are like. I may end up just running my natural gas furnace the rest of the winter after I run out of coal. Natural gas is still dirt cheap, however, I much prefer the radiant heat the Mark I provides. House feels more comfortable with the coal fire versus the forced air heat from my primary furnace. ¯\_(ツ)_/¯

Attachments

IMG_1791.jpg
.JPG | 399.5KB | IMG_1791.jpg

 
nut
Member
Posts: 1478
Joined: Wed. Aug. 28, 2019 1:54 pm
Location: NEPA
Hand Fed Coal Stove: Glacier Bay
Coal Size/Type: nut
Other Heating: electric

Post by nut » Mon. Dec. 26, 2022 11:33 am

May I suggest a bin in the basement to complete your transformation. Just pull the truck up and drop it in. If you can position it near the stove you can shovel it directly in without moving your feet. Nice.

Post Reply

Return to “Hand Fired Coal Stoves & Furnaces Using Anthracite”