New User- CRANE 404 needs help!

Post Reply
 
User avatar
coaledsweat
Site Moderator
Posts: 13768
Joined: Fri. Oct. 27, 2006 2:05 pm
Location: Guilford, Connecticut
Stoker Coal Boiler: Axeman Anderson 260M
Coal Size/Type: Pea

Post by coaledsweat » Sat. May. 09, 2020 8:55 pm

I would try brazing it. No need to get fancy if it's inside the stove. Just get it clean and heat it up real good then braze away. A stove for nothing is a good score no sense throwing a ton of money at it!
Top
 
User avatar
freetown fred
Member
Posts: 30302
Joined: Thu. Dec. 31, 2009 12:33 pm
Location: Freetown,NY 13803
Hand Fed Coal Stove: HITZER 50-93
Coal Size/Type: BLASCHAK Nut

Post by freetown fred » Sat. May. 09, 2020 9:25 pm

A REAL BIG +1 on that C!! :)
Top
Visit DS Stove
 
Holdencoal
Member
Posts: 673
Joined: Sun. Nov. 17, 2019 2:17 pm

Post by Holdencoal » Sat. May. 09, 2020 9:58 pm

If it was me I would use INCO Alloys International, Inc. NI-ROD 55 to weld the pot.
Top
 
Wackydiver69
New Member
Posts: 5
Joined: Sat. May. 09, 2020 6:39 pm
Hand Fed Coal Stove: Crane stove 404
Coal Size/Type: Nut

Post by Wackydiver69 » Sun. May. 10, 2020 12:43 am

Thank you all
Top
Post Reply

Return to “Hand Fired Coal Stoves & Furnaces Using Anthracite”