Hitzer 30-95 flu size/new construction
-
- Member
- Posts: 54
- Joined: Wed. Sep. 12, 2018 7:35 am
- Location: Central NY
- Hand Fed Coal Stove: Hitzer 30-95
- Coal Size/Type: Anthracite/nut
I will be building a new house in a few weeks. 2000 sq ft ranch, walk out basement, central New York(it gets cold). The main heat source will be forced air/propane. I purchased a one year old Hitzer 30-95 to be used for emergency heat that will be located in the basement. I probably should have bought the next size larger but the damage is done. I emailed Hitzer regarding flue size/material and they suggested an 8 inch flue and to use 316 stainless. Some people tell me I may have draft issues with the 8 inch. I have never used a coal stove before, this is all new to me. I have not purchased the pipe yet so I was hoping someone might have an opinion on this. I plan on boxing the pipe in once it is installed.
I may fix up half my basement to use as a tv room in the future. Would the 30-95 put out enough heat to keep a 2000 sq ft basement comfortable?
Would I be better off with the 8 inch flue in case I decide to install a larger stove in the future?
Sorry if these questions have been asked a hundred times before. I appreciate any/all advice.
I may fix up half my basement to use as a tv room in the future. Would the 30-95 put out enough heat to keep a 2000 sq ft basement comfortable?
Would I be better off with the 8 inch flue in case I decide to install a larger stove in the future?
Sorry if these questions have been asked a hundred times before. I appreciate any/all advice.
- buffalo bob
- Member
- Posts: 961
- Joined: Tue. Feb. 07, 2012 12:41 pm
- Location: scpa. bedford co. buffalo mills
- Hand Fed Coal Stove: hitzer 354 and a 254
- Coal Size/Type: anthracite nut
8"" flue is plenty, but if new construction i would buil masonry flue with clay liner, last forever...
-
- Member
- Posts: 54
- Joined: Wed. Sep. 12, 2018 7:35 am
- Location: Central NY
- Hand Fed Coal Stove: Hitzer 30-95
- Coal Size/Type: Anthracite/nut
Hitzer told me the same thing, but they did say the 316 stainless should last quite a while. The guy building my house told me that if I only plan on using the stove occasionally the clay will turn to powder in short time. It is only if it gets hot and stays hot for the season that it lasts practically forever. He claims he has repaired many chimneys in which they clay essentially disintegrated from only periodic use. Any truth to that?
Thanks for the reply.
Thanks for the reply.
- Lightning
- Site Moderator
- Posts: 14669
- Joined: Wed. Nov. 16, 2011 9:51 am
- Location: Olean, NY
- Stoker Coal Boiler: Modified AA 130
- Coal Size/Type: Pea Size - Anthracite
I've never heard anything like that before about a clay tiled chimney. What I can tell you is that I had a propane furnace vented thru my exterior clay lined chimney for about 8 years. It seemed to me that the moisture from the propane exhaust did condense and freeze at the top of the chimney causing the top two courses of masonry brick to crumble from the freeze thaw cycle of the furnace on and off again. I replaced the top two courses myself when I changed over to coal. I don't know for sure if the propane furnace caused the crumbling or not but since my chimney has two flues the side with the most damage was the propane flue. So it made sense to me.
- warminmn
- Member
- Posts: 8190
- Joined: Tue. Feb. 08, 2011 5:59 pm
- Location: Land of 11,842 lakes
- Hand Fed Coal Stove: Chubby Junior, Riteway 37
- Coal Size/Type: nut and stove anthracite, lignite
- Other Heating: Wood and wear a wool shirt
There are lots of 100 year old clay thimble chimneys around that havent been used for years and are still good. Your builder may be thinking of something else.
- freetown fred
- Member
- Posts: 30300
- Joined: Thu. Dec. 31, 2009 12:33 pm
- Location: Freetown,NY 13803
- Hand Fed Coal Stove: HITZER 50-93
- Coal Size/Type: BLASCHAK Nut
I would seriously consider the 50-93---big brother to the 30-95--best to have to much that you can idle down when needed then to be lacking when you need it. Post the 30-95 for sale here, & local places- Cortland Standard, TSC, etc. I'd bet it wouldn't last long if your asking price is reasonable. FYI--my 50-93 uses 6" stainless--can't imagine why Dean would of suggested 8"??????????????
Fap i have the 3095 stove for 19 years .I will say its Marginal for your basement .Definitely insulate the walls or the concrete walls Will Act As A Heat Sink an render near useless for heat .Chimney Get a masonry tiled chimney .I an Buffalo are masons each over 40 years .Brick or Block chimney will last a Long Long time .jack Also the 5093 is Better suited for basement .
- oliver power
- Member
- Posts: 2970
- Joined: Sun. Apr. 16, 2006 9:28 am
- Location: Near Dansville, NY
- Stoker Coal Boiler: KEYSTOKER Kaa-2
- Hand Fed Coal Stove: Hitzer 50-93 & 30-95, Vigilant (pre-2310), D.S. 1600 Circulator, Hitzer 254
I'll back the other replies. Masonry Chimney, and 50-93. The 30-95 is small for basement application. You'd have to run the 30-95 too hard. When "running hard", the 30-95 will use more coal, and make nice clinkers.
Maybe HITZER was talking an 8" masonry chimney flue. That would be fine. If going metal, 6" 316 is what you'd want. With a new build, it's a no brainer. Go Masonry...
Maybe HITZER was talking an 8" masonry chimney flue. That would be fine. If going metal, 6" 316 is what you'd want. With a new build, it's a no brainer. Go Masonry...
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
My wild guess would be no 6" for wood or bituminous...you're skating by by burning anthracite, and also might have minimal bends and reasonable length. With added bends and length the 6" ability to move enough exhaust may not happen.freetown fred wrote: ↑Wed. Oct. 03, 2018 4:51 pmI would seriously consider the 50-93---big brother to the 30-95--best to have to much that you can idle down when needed then to be lacking when you need it. Post the 30-95 for sale here, & local places- Cortland Standard, TSC, etc. I'd bet it wouldn't last long if your asking price is reasonable. FYI--my 50-93 uses 6" stainless--can't imagine why Dean would of suggested 8"??????????????
No two chimneys are alike, as they say.
- freetown fred
- Member
- Posts: 30300
- Joined: Thu. Dec. 31, 2009 12:33 pm
- Location: Freetown,NY 13803
- Hand Fed Coal Stove: HITZER 50-93
- Coal Size/Type: BLASCHAK Nut
Old school would be if you've got a 6" outlet on your stove--stick with it--both 30-95 & 50-93 have 6" outlets.
-
- Member
- Posts: 283
- Joined: Tue. Jan. 13, 2015 8:49 am
- Location: Springwater NY, (Western NY)
- Hot Air Coal Stoker Stove: Keystoker 105 - SOLD
- Hand Fed Coal Stove: Hitzer 30-95 - Garage
- Hand Fed Coal Furnace: HITZER 50-93 - HOUSE
- Coal Size/Type: NUT
- Other Heating: PROPANE FURNACE, ELECTIC BASE BOARD, AND WOOD FIRE PLACE
Running 6" stainless on both a 50-93 in the house and a 30-95 in the garage. Also ran a Keystoker 105 on the same 6" stainless.
- McGiever
- Member
- Posts: 10130
- Joined: Sun. May. 02, 2010 11:26 pm
- Location: Junction of PA-OH-WV
- Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
- Hand Fed Coal Boiler: BUCKET A DAY water heater
- Hand Fed Coal Stove: Warm Morning 414A
- Coal Size/Type: PEA,NUT,STOVE /ANTHRACITE
- Other Heating: Ground Source Heat Pump and some Solar
Sometimes I do lose sight that these are just 'space heaters'.
-
- Member
- Posts: 283
- Joined: Tue. Jan. 13, 2015 8:49 am
- Location: Springwater NY, (Western NY)
- Hot Air Coal Stoker Stove: Keystoker 105 - SOLD
- Hand Fed Coal Stove: Hitzer 30-95 - Garage
- Hand Fed Coal Furnace: HITZER 50-93 - HOUSE
- Coal Size/Type: NUT
- Other Heating: PROPANE FURNACE, ELECTIC BASE BOARD, AND WOOD FIRE PLACE
I've run both stoves as hard as they can run in the house and the garage through the 6" pipe. Works great. I actually had to put a manual pipe damper in to slow it down so i don't loose all my heat up the chimney! Big draft.