Re: Managing Low Slow Burns
Posted: Mon. Mar. 27, 2017 10:08 pm
It might be your browser Fred. My more smilies works fine using google.... Perhaps you were hacked by the EPA!
Using anthracite or bituminous coal for residential and commercial heating.
https://coalpail.com/coal-forum/
I've had my eye on the 82FA so far.oliver power wrote:By the way Lightning; What HITZER model were you thinking?
There's no pullin' the wool over your eyes. Opps,.... I made a sheep joke.freetown fred wrote:Oh, I get it. That was a pun right??? LOL where the hell did my "more smilies" go?????????????????? RICHARD??????????? Damn, my trademark, GONE!!!!!!!!!!!!!!!
Lightning wrote:......I've had my eye on the 82FA so far.
Yeah that's an awesome idea too. I've been wondering if I could cover half the grate area with a steel plate. I have the "V" shaped fire bed so a piece of steel wide enough to wedge against the sides a couple inches above the grate would leave room to continue using the shaker.blrman07 wrote:Gonna be time to let half the firebox ash up and only feed half the stove. Did that the last two years. It worked out great. Can't use the shaker to de-ash, you have to slice and dice. If you used the shaker you lose the side with nothing but ash.
It's a lot more convenient that putting in firebrick don't ya know?
Yes, I started doing this at the end of last year. I let the ash build up around the outside edge, it makes a little cone shaped nest for the actively burning coal and just fill up on top of that then poke from underneath just in the center. Works very nicely for a slow and low burn.blrman07 wrote:Gonna be time to let half the firebox ash up and only feed half the stove.
Lee, could you disconnect the back grate and stack fire brick in half of the grate area? This way nothing gets moved around back there when you shake.Lightning wrote:Yeah that's an awesome idea too. I've been wondering if I could cover half the grate area with a steel plate. I have the "V" shaped fire bed so a piece of steel wide enough to wedge against the sides a couple inches above the grate would leave room to continue using the shaker.
Sort of what I did but I found firebrick performs better. Ash can bleed draft off the fire to a small extent, brick doesn't. Not always evident but it can make a little difference on the warm days when draft is at a premium.Lightning wrote:Yeah that's an awesome idea too. I've been wondering if I could cover half the grate area with a steel plate. I have the "V" shaped fire bed so a piece of steel wide enough to wedge against the sides a couple inches above the grate would leave room to continue using the shaker.blrman07 wrote:Gonna be time to let half the firebox ash up and only feed half the stove. Did that the last two years. It worked out great. Can't use the shaker to de-ash, you have to slice and dice. If you used the shaker you lose the side with nothing but ash.
It's a lot more convenient that putting in firebrick don't ya know?
I don't think my grates will come apart. I have them drilled and tapped with set screws. Those screws aren't gonna come loose after the abuse they've taken with heat and shaking.michaelanthony wrote:Lee, could you disconnect the back grate and stack fire brick in half of the grate area? This way nothing gets moved around back there when you shake.
I've thought of disconnecting the 50-93 linkage, but never did. That's where the 30-95 shines with its single grate, low fire burning.freetown fred wrote:That would work well with my 50-93 MA--Got a pin & cotter pin connecting the 2 grates.