Rice Coal in an Oak Stove

Post Reply
 
PJT
Member
Posts: 456
Joined: Fri. Jan. 06, 2012 11:11 pm
Location: South Central CT
Baseburners & Antiques: Magee Royal Oak; Glenwood Modern Oak 116
Other Heating: propane

Post by PJT » Tue. May. 17, 2016 6:43 pm

Hi Everybody

Is it possible to burn rice coal in an oak stove with ok results?

Something tells me it might not turn out well...

 
franco b
Site Moderator
Posts: 11417
Joined: Wed. Nov. 05, 2008 5:11 pm
Location: Kent CT
Hand Fed Coal Stove: V ermont Castings 2310, Franco Belge 262
Baseburners & Antiques: Glenwood Modern Oak 114
Coal Size/Type: nut and pea

Post by franco b » Tue. May. 17, 2016 8:40 pm

With some means to keep it from falling through the great and a very shallow bed I think it would work OK. A lined fire pot would help.

 
User avatar
Sunny Boy
Member
Posts: 25706
Joined: Mon. Nov. 11, 2013 1:40 pm
Location: Central NY
Hand Fed Coal Boiler: Anthracite Industrial, domestic hot water heater
Baseburners & Antiques: Glenwood range 208, # 6 base heater, 2 Modern Oak 118.
Coal Size/Type: Nuts !
Other Heating: Oil &electric plenum furnace

Post by Sunny Boy » Tue. May. 17, 2016 10:11 pm

Yeah, the big problem is going to be keeping it on top of the grates. Most oaks are meant to handle nut, or stove size.

There's no way rice would stay on the grates of my oaks.

Paul


 
PJT
Member
Posts: 456
Joined: Fri. Jan. 06, 2012 11:11 pm
Location: South Central CT
Baseburners & Antiques: Magee Royal Oak; Glenwood Modern Oak 116
Other Heating: propane

Post by PJT » Tue. May. 17, 2016 11:27 pm

I suppose I could use it to slow down the fire when burning nut or stove?

 
User avatar
Richard S.
Mayor
Posts: 15235
Joined: Fri. Oct. 01, 2004 8:35 pm
Location: NEPA
Stoker Coal Boiler: Van Wert VA1200
Coal Size/Type: Buckwheat/Anthracite

Post by Richard S. » Wed. May. 18, 2016 6:34 am

I know a relative that burned rice in a Franco Belge but those grates are pretty small, you can use buckwheat in one of them without any issues which is about the size of a dime. I know with the rice he had to be very careful shaking the grates and he wasn't getting a lot of heat but it wasn't burning up quick either.
PJT wrote:I suppose I could use it to slow down the fire when burning nut or stove?
I had customer that used it for that, he used to get 4 ton of nut and we'd chute 1 ton of rice to the side of the bin. He used to throw it over the fire at night. Quick tip, you can do the same thing with ash.

 
User avatar
Canaan coal man
Member
Posts: 822
Joined: Thu. Nov. 08, 2012 12:37 pm
Location: East Canaan, CT
Stoker Coal Boiler: Efm 520
Hand Fed Coal Stove: A little cubby coal stove in the basement
Baseburners & Antiques: Glenwood #6
Coal Size/Type: Stove And Nut

Post by Canaan coal man » Wed. May. 18, 2016 9:25 am

I used it a few times to help slow draft pull on a windy day its ok but it was a a pain as it flowed thru the burn cycle and turned to ash it would slow draft even more than expected, I spent more time screwing with primary air and baby sitting than needed

Post Reply

Return to “Hand Fired Coal Stoves & Furnaces Using Anthracite”