Page 1 of 1
Monometer Part Numbers
Posted: Tue. Apr. 15, 2014 11:47 am
by loxety
I took a picture of part #'s needed from home depot to add all metal parts to the flu in order to hook up a manometer (and not have it melt).
This gets the plastic parts about 1.5-2 ft away from any heat.
Re: Monometer Part Numbers
Posted: Thu. Apr. 17, 2014 7:56 pm
by McGiever
I see a couple different brass fittings and small coil of soft copper tubing...Thanks for sharing.
Re: Monometer Part Numbers
Posted: Thu. Apr. 17, 2014 10:49 pm
by loxety
there is a 90 degree fitting that bolts to the flue that has a compression fitting that goes to the straight copper tube then a compression fitting on the other end (coupler?) where the plastic tube connects from the manometer
I'll take some closer shots of the setup when I get the time