Monometer Part Numbers

Post Reply
loxety
Member
Posts: 56
Joined: Fri. Feb. 15, 2013 10:39 pm
Hand Fed Coal Stove: Harman Mark II
Coal Size/Type: Blaschak Nut
Location: Winchester, VA

Post Tue. Apr. 15, 2014 11:47 am

I took a picture of part #'s needed from home depot to add all metal parts to the flu in order to hook up a manometer (and not have it melt).

This gets the plastic parts about 1.5-2 ft away from any heat.
Attachments
Manometer parts.jpg
Manometer parts connected.jpg

User avatar
McGiever
Member
Posts: 6074
Joined: Sun. May. 02, 2010 11:26 pm
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Coal Size/Type: PEA / ANTHRACITE
Other Heating: Ground Source Heat Pump
Stove/Furnace Make: Hydro Heat /Mega Tek
Location: Junction of PA-OH-WV

Post Thu. Apr. 17, 2014 7:56 pm

I see a couple different brass fittings and small coil of soft copper tubing...Thanks for sharing. :)

Visit Hitzer Stoves

loxety
Member
Posts: 56
Joined: Fri. Feb. 15, 2013 10:39 pm
Hand Fed Coal Stove: Harman Mark II
Coal Size/Type: Blaschak Nut
Location: Winchester, VA

Post Thu. Apr. 17, 2014 10:49 pm

there is a 90 degree fitting that bolts to the flue that has a compression fitting that goes to the straight copper tube then a compression fitting on the other end (coupler?) where the plastic tube connects from the manometer

I'll take some closer shots of the setup when I get the time :D

Post Reply

Return to “Hand Fired Coal Stoves & Furnaces Using Anthracite”